Hearth & Home Technologies 42-B User Manual

4

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Dakota 42-B/Dakota 42H-B • 4036-909 • Rev L 10/09

This  product  is  listed  to ANSI  standards  for  “Vented  Gas

Fireplaces” and applicable sections of “Gas Burning Heating

Appliances for Manufactured Homes and Recreational Vehi-

cles”, and “Gas Fired Appliances for Use at High Altitudes”.

Do NOT use this appliance if any part has been under

water. Immediately call a qualified service technician 

to inspect the appliance and to replace any part of the

control system and any gas control which has been

under water.

MODELS:   Dakota 42-B, Dakota 42H-B

LABORATORY:   Underwriters Laboratories, Inc. (UL)

TYPE:    Vented Gas Appliance 

Note: This installation must conform with local codes. In the

absence of local codes you must comply with the

Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A.

and the

 CAN/CGA B149 Installation Codes in Canada.

Hearth & Home Technologies appliances manufactured with

tempered glass may be installed in hazardous locations such

as bathtub enclosures as defined by the Consumer Product 

Safety Commission (CPSC). The tempered glass has been

tested and certified to the requirements of ANSI Z97.1 and 

CPSC  16  CFR  1202  (Safety  Glazing  Certification  Council 

SGCC# 1595 and 1597. Architectural Testing, Inc. Reports

02-31919.01 and 02-31917.01).
This statement is in compliance with CPSC 16 CFR Section

1201.5 “Certification and labeling requirements” which refers 

to 15 U.S. Code (USC) 2063 stating “…Such certificate shall 

accompany the product or shall otherwise be furnished to

any distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered glass

with  permanent  marking  in  such  locations.  Glass  meeting

this requirement is available from the factory. Please contact

your dealer or distributor to order.

Dakota 42-B (NG)

60,000

25

Dakota 42-B (LP)

53,000

44

U.L. Listed gas appliances are tested and approved without

requiring changes for elevations from 0 to 2000 feet in the

U.S.A. and Canada.
When installing this appliance at an elevation above 2000 ft,

it may be necessary to decrease the input rating by chang-

ing the existing burner orifice to a smaller size. Input rate 

should be reduced by 4% for each 1000 ft above a 2000 ft

elevation in the U.S.A., or 10% for elevations between 2000

and 4500 ft in Canada. If the heating value of the gas has

been reduced, these rules do not apply. To identify the prop-

er orifice size, check with the local gas utility.
If installing this appliance at an elevation above 4500 ft (in

Canada), check with local authorities.