Black Box UCCDL18H User Manual
Page 15
724-746-5500 | blackbox.com
UCCDM20-T
Chapter 4: Configuration and Setup
4.2 Routing the Cable (UCCDS20T, UCCDS20H, UCCDS30T, UCCDS30H,
UCCDS40T, UCCDS40H)
UCCDS40T, UCCDS40H)
1. At the back of the cart, loosen the two screws on the cable manager, pull up
on the top section of the cable manager, and place the device side of the
charging cable into one of the slots. (See Figure 4-2.)
charging cable into one of the slots. (See Figure 4-2.)
Cable
manager
Route cable to the
front of the cart
Loosen screws on cable manager
and pull up
Wrap excess cable
around cable wrap
Power
Strip
Charger
Figure 4-2. Small shelf routing instructions.
2. Replace the top section of the cable manager and tighten the screws.
3. Route the device side of the charging cable to the front of the cart and repeat
step 1 for the front cable manager.
4. Wrap any excess cable around the cable wrap on the back of the shelf.
5. Plug the charger power plug into the power strip located below the shelf.