Emerson 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 C R 0 2 0 R A 1 C 7 S D 1 8 1 1 E L 1 0 P A User Manual

Network Safe—This parameter saves or loads network settings for the display that have been 

modified from the factory defaults to an internal file that can be downloaded / uploaded using the 

Liebert iCOM

®

 Service Tool. Selecting “Save” will write the settings to the internal storage file and 

selecting “Load” will write the settings from the internal storage file to the application software.
SW Version—This parameter contains the application software version loaded into the Liebert 

iCOM display.

IP Address—This parameter contains the network address of the display. This address must be 

unique to every other device on the network.
Netmask—Not currently used.
Gateway—Not currently used.
MAC—The MAC address is a unique hardware identifier of the Ethernet device.
U2U Protocol—This parameter is always set to GBP.
U2U Address—This parameter is a unique identifier for each unit on the network. Display addresses 

range from 33 to 64. Each display on the U2U network must have a different U2U address.
U2U Group—This parameter is used to create zones or groups within a U2U network. Once a group 

number is selected the display will only see other devices with the same group number. The group 

number can be changed to view other devices in different groups.
Bootloader Variables—This parameter indicates if there has been a change to the bootloader since 

it was last loaded. This parameter should only be activated by an authorized service person.

S812
S813
S814
S815
S816
S817
S818
S819
S820
S821
S822

PASSWORD

(Actual Level 0)

????

IP Address

10.203.062.150

Netmask

255.255.255.192

Gateway

10.203.062.129

MAC

00:00:68:19:0B:58

U2U Protocol

GBP

U2U Address

33

U2U Group

13

Bootloader Variables

Changed

No

SYSTEM / NETWORK SETUP (page 2 of 2)

SYSTEM

to change parameter

for next/previous unit

to select parameter

to confirm

then