Ultimate Support Systems LTV-24B Leaflet

3

z

Convert a speaker stand into a lighting tree.

z

48” crossbar has 4 pre-drilled holes for mounting hardware (included), AND is 
thick-walled for use with C-clamps (not included).

z

Weight Rating: 60 lbs. (27.2 kg)

z

Parts:
1) 48” tube with end plugs

1) 2-piece hatched t-fitting

2) Universal fittings

1) Hardware packet

STEP 2: Assemble each T-fitting with the 3 Handknobs.  Install
hex nuts, insert Handknob with washer - loosely tighten
Handknobs.

STEP 4: Optional: Slide one Universal Fitting for dimmer packs
on the Tube - place on either side of the T-fitting. Install
Handknobs. 

STEP 5: Slide T-Fitting  over top tube of the tripod stand and
tighten corresponding Handknobs onto top tube. Tighten
Handknob for the Crossbar Tube.

STEP 6: Assemble mounting Hardware through par can yoke or
other lighting effect in order shown (bolt, washer, saddle, tube,
saddle, washer, t-nut). OR  tighten C-clamps directly onto the
tube.

STEP 1: Set up tripod stand following enclosed instructions. 

STEP 7: Raise height of lighting tree following enclosed
tripod instructions.

2.

3.

5

.

6.

STEP 3: Slide T-fitting to middle of the Crossbar Tube. Leave
Handknob loose.

z

Add a second tier to your lighting tree.

z

Each 24” crossbar arm has 2 pre-drilled holes for mounting hardware (included),  
AND is thick-walled for use with C-clamps (not included).

z

Weight Rating: 20 lbs. (9.1 kg) per arm

z

Parts:
2) 24” tubes with end plugs 2) 2-piece hatched t-fitting
2) Universal fittings

1) Hardware packet

STEP 1: Set up tripod stand following enclosed instructions. 
STEP 2:  Follow LTB-48B Step 2 for assembling T-fittings.  
STEP 3:  Optional: Follow LTB-48B Step 4 for Universal 

Fitting - one per tube.

STEP 4:  Slide closed end of T-fitting back on the open end 

of the Tube. Tighten corresponding Handknobs.

STEP 5:  Slide T-fittings  (with  Tubes in a horizontal line) over the top tube of the  

tripod stand (inset). Tighten remaining Handknobs.

STEP 6:  Follow LTB-48B Step 6 for attaching par cans or other lighting effects to 

the Crossbar Tube.

STEP 7:  Raise height of lighting tree following enclosed tripod instructions.

2

z

Make a lighting tree 24” taller.

z

Parts:
1) 24” tubes with end plug 

and connector

1) Hardware packet

STEP 1: Place Extension Tube 

over top of the speaker
stand.

STEP 2:  Tighten socket-head cap

screws with allen wrench.

1. Follow all Setup and Special 

Instructions on enclosed Tripod 
Stand sheet.

2. Universal Fittings are intended for

use with dimmer packs only - DO
NOT USE WITH LIGHTING 
FIXTURES.

3. Distribute weight equally over 

Lighting Tree System.  

4. Check that handknobs are secure

when supporting equipment and 
always loosen handknobs with 
caution

.