Furuno 1712 User Manual

 

 

Caution

Cable clamp

Rotation detector

Shield plate

 

Caution: Be careful not to pinch the 
rotation detector cable when remounting 
the shield plate.   

7.    Pass the antenna cable with connector 

through the gasket and cable clamp, and 
then tighten cable gland. 
Be sure the shrink tubing on the antenna 
cable is not covered by the gasket. 

Rubber gasket

Gasket

Cable Gland

Sectional view

Mounting base

Rubber gasket

 

8.    Referring to Figure 8, fasten the shield 

cable with screw (M4x10) on the chassis to 
ground the unit.   

Connect 9 pin 
connector 
here (J801).

Connect
shield here.

 

9.  Attach EMI Core (supplied) to antenna 

cable. Set the fixing band to the EMI core.   

This bend should be 
facing toward you.

Fixing band

 

10. Referring to Figure 8, connect the 9-pin 

connector of the antenna cable to J801. 

11. Refasten the shield plate with 10 screws. 

Be sure not to pinch cable from the rotation 
detector with the shield plate. See “Caution” 
in Figure 6 for details. 

12. Fasten the Fixing band with Screw 

(supplied). 

Screw(M4X15)

EMI Core

Fixing 
Band

Align bend with 
corner of chassis.

 

13. Follow the instructions on the label inside 

the mounting base to secure the snap assy. 

14. Confirm that the rubber gasket is properly 

positioned and that the triangle mark on the 
radome cover is aligned with the triangle 
mark on the mounting base, then tighten 
the fixing screws for the cover. Refer to 
Figure 7 for positioning of rubber gasket.