Graco 312964C User Manual

7.

Install two, 9-volt alkaline batteries (1). Be sure that 
the batteries fully engage the mounting clips by 
pushing on the bottom of each battery with your 
thumb.

8.

Replace insulating foam (4).

9.

Replace cover (7) and secure it with the four screws 
(3).

It will take about 30 seconds for the monitor to dis-
play information after pressing the Display button 
on the initial power-up. This time will decrease 
thereafter to a few seconds

Make sure the gasket (2) is not damaged and is in 
the correct location.

Make sure the cover screws are tightened securely 
(18-22 in-lb) to avoid water leakage into the TLM 
electronics. If a torque wrench is not used, verify 
there are no gaps under the screw heads and no 
gaps under the cover flange. This will ensure 
proper compression of the gasket for a water-tight 
seal.

1

2

3

4

on

1

2

3

4

on

All dipswitches in down 
or off position.

All dipswitches
to right or off
position.

 

ti12007a