Furuno FSV-35 User Manual

A special crimping tool is necessary for connection of wires to the contact pins of the 
10P connector. The pin extractor removes the contact pin from the connector body. 

1. Remove the vinyl sheath by 3 to 4 mm to expose the core. 
2. Hold the crimping tool horizontally and insert 

the contact pin with its slit facing downward 
into the crimp hole on the crimping tool.

3. Insert the wire onto the contact pin and 

squeeze the handle until the rachet releases. 
(The wire should be placed deep enough into 
the contact pin so that its end comes in con-
tact with the stopper plate of the crimping 
tool.) 

4. With crimping completed, pull the wire while 

holding the contact pin to make sure that the wire is held firmly by the contact pin.

If a contact pin is inserted into an incorrect 
hole on the connector body, remove it with the 
pin extractor.

1.  Push the pin extractor into the pin hole 

from the side opposite to the pin inserting 
side.

2. Push in the head of the pin extractor. The 

retaining spring comes free and the con-
tact pin can be removed. 

Crimping Tool

06-1001-016

Contact Pin

60-8017-0313-00339F

(000-159-417-10)

Pin Extractor

06-1877-04

(000-519-595)