Graco 249881 User Manual

When the meters were originally programmed by the 
system administrator, one of the following security 
choices was entered: 

•

System Monitoring

•

PIN  Code

•

Parts Room Authorization

Prior to dispensing, it may be necessary to complete 
one of the following security procedures, depending on 
the security mode selected.

When set for system monitoring, no security authoriza-
tion is required by the operator. However, any amount of 
fluid dispensed is automatically sent by the meter to the 
PC where it is recorded for future reference.

PIN Code (personal identification number) means that a 
four digit PIN code must be entered at the meter to 
obtain dispense authorization. To use a meter with PIN 
code security:

1.

Use the up and down arrow keypad buttons to select 
the first number of the PIN code. 

2.

Press the right keypad button to move the cursor to 
the next position. 

3.

Use the up and down keypad buttons to select the 
desired number. Continue this process until the PIN 
code number is completed. See F

IG

. 12.

4.

When the pin code is complete, press the right key-
pad button until the cursor underlines the Enter 
option. Press the up arrow on the meter keypad. 
This action will enter the PIN code and send it to the 
PC.

5.

The PC recognizes the PIN code and authorizes the 
meter to dispense. 

This mode provides high level security and requires a 
Parts Room Administrator to authorize each dispense. 

1.

Press either the left keypad or right keypad button 
under REQUEST APPROVAL. This sends the 
request to the parts room administrator’s PC for dis-
pense authorization. See F

. 13.

2.

The administrator grants authorization at the PC, 
which then authorizes the meter to dispense.