Sony PCS-1P User Manual
3-10
PCS-1/1P
2.
Confirm that the IP address is displayed in the launcher menu of teleconference terminal B.
(Example: IP:192.100.20.20)
(Example: IP:192.100.20.20)
3.
Confirm that “Registration Confirm” is displayed at the bottom of page 2 in the LAN setup menu of
teleconference terminal B.
teleconference terminal B.
4.
The LAN setup menu of teleconference terminal A is set as described below.
DHCP Mode:
DHCP Mode:
ON
Host Name:
Enter any name.
IP Address:
Blank
Network Mask:
Blank.
Gateway Address:
Blank
DNS Address:
Blank
Gatekeeper Mode:
ON
Gatekeeper Address:
192.100.10.20
User Alias:
Enter any name. (Example: PCS1A)
User Number:
Enter any number. (Example: 100)
SNMP Mode:
OFF
Trap Destination:
Blank
Community:
public
Description:
Videoconference Device
Location:
Blank
Contact:
Blank
NAT Mode:
OFF
NAT Address:
Blank
Packet Resend Request: Blank
Adaptive Rate Control: OFF (Set to ON when a packet loss occurs frequently.)
LAN Mode:
LAN Mode:
Auto Nagotiation (This mode is changed to a proper mode when mismatching
occurs in the mode. Refer to “4-2. PCS-1/1P and Hub setting”.)
Port Number Used:
Default (Set to “Custom” when a port number is specified by the network
administrator.)
TCP Port Number:
2253 (Enter the port number specified by the network administrator when
the port number used is set to “Custom”.)
UDP Port Number:
49152 (Enter the port number specified by the network administrator when
the port number used is set to “Custom”.)
TOS:
OFF
PPPoE:
OFF
PPPoE User Name:
Blank
PPPoE Password:
Blank
Fixed IP for PPPoE:
OFF
Fixed IP Address for PPPoE: Blank
PPPoE DNS:
PPPoE DNS:
Obtain automatically
Primary DNS:
Cannot be set.
Secondary DNS:
Cannot be set.
5.
Confirm that the IP address is displayed in the launcher menu of teleconference terminal A.
(Example: IP:192.100.10.10)
(Example: IP:192.100.10.10)
6.
Confirm that “Registration Confirm” is displayed at the bottom of page 2 in the LAN setup menu of
teleconference terminal A.
teleconference terminal A.
7.
Enter LAN in the dial list of teleconference terminal A for a line I/F, user name PCS1B or user
number 200 of teleconference terminal B in it for an IP address, and other required items. After that,
number 200 of teleconference terminal B in it for an IP address, and other required items. After that,
register teleconference terminal B and initiate a call. Or set LAN for a line I/F and user name PCS1B
or user number 200 of teleconference terminal B for an IP address by Dial, and then initiate a call.
or user number 200 of teleconference terminal B for an IP address by Dial, and then initiate a call.