Pelco C528M-E User Manual
C528M-E (4/03)
7
MPTAZ115DT or MAPTAZ220DT - Assemble the mating connector. Refer to Figure 4 and perform the following steps.
a.
Slide the connector clamp assembly over the conductor cable. If the diameter of the conductor cable is such that the rubber
boot will slide over it easily, slide the rubber boot onto the conductor cable at this time. If not, discard the rubber boot.
boot will slide over it easily, slide the rubber boot onto the conductor cable at this time. If not, discard the rubber boot.
b.
Refer to Detail A in Figure 4. Prepare the wires from the conductor cable as follows:
•
Strip at least one inch (2.54 cm) from the cable jacket to expose the wires. You may need to strip more from
the cable jacket if you have more wires.
the cable jacket if you have more wires.
•
Strip .125-inch (3 mm) from each wire.
•
Use an AMP style crimper, crimp the wires and their insulation to the connector pins.
NOTE: Contacts cannot be removed from the connector without the use of the appropriate AMP extraction tool
(ZT305183), which is available from Pelco.
(ZT305183), which is available from Pelco.
c.
Slide the connector pins into the appropriate holes in the connector body until they snap into place. Refer to detail B
in Figure 4 and to Figures 5 and 6 for the correct pin arrangement.
in Figure 4 and to Figures 5 and 6 for the correct pin arrangement.
d.
Push the connector clamp assembly (with boot, if used) toward the connector body. Screw the clamp assembly onto
the connector body, being careful not to disturb the wires.
the connector body, being careful not to disturb the wires.
e.
To complete the assembly, attach the appropriate clamp with the screws provided and tighten.
f.
Wire the connecting cable from the pan/tilt or scanner to the controller. Refer to one of the following wiring
diagrams: Figure 5 (scanners) or Figure 6 (pan/tilts).
diagrams: Figure 5 (scanners) or Figure 6 (pan/tilts).
3.
Plug the control’s power cord into an AC outlet. The unit powers-up in manual operation mode; the MANUAL LED turns on.
Figure 4. Connector Assembly
Figure 5. MPTAZ115DT, MPTAZ220DT Wiring
Diagram for Scanners and Lenses
Figure 6. MPTAZ115DT, MPTAZ220DT Wiring
Diagram for Pan/Tilts and Lenses
OR
1"
1/8"
FRONT VIEW
1
3
4
7
8
12
14
11
1
3
4
5
6
7
8
3
4
5
6
7
8
10
12
11
13
12
11
13
PT COMMON
LEFT
AUTO
DOWN
UP
RIGHT
SAFTY GND
IRIS
ZOOM
FOCUS
LENS COM
LEFT
AUTO
DOWN
UP
RIGHT
SAFTY GND
IRIS
ZOOM
FOCUS
LENS COM
TO SCANNER
CONNECTOR
TO LENS
CONNECTOR
1
3
4
5
6
7
8
3
4
5
6
7
8
10
12
11
13
12
11
13
PT COMMON
LEFT
AUTO
DOWN
UP
RIGHT
SAFTY GND
IRIS
ZOOM
FOCUS
LENS COM
LEFT
AUTO
DOWN
UP
RIGHT
SAFTY GND
IRIS
ZOOM
FOCUS
LENS COM
TO PAN/TILT
CONNECTOR
TO LENS
CONNECTOR