Xantrex Technology XS400 User Manual
Installation
2–22
975-0054-01-01
Step 10: Performing Checks Prior to Initial Start-up
Before starting up your inverter, ensure these conditions are met:
❐ Chassis ground is properly installed
❐ On/Standby switch is in the Standby ( ) position on both the XS400
and S400 Remote Switch
❐ Positive (+) battery cable is connected to the positive (+) battery
terminal through the DC fuse and Disconnect or DC circuit breaker
❐ Negative (–) battery cable is connected to the negative (–) battery
terminal
❐ Battery voltage is within the proper range for this unit
(10.3–15.3 volts DC)
❐ DC Fuse is intact (not blown)
Step 11: Connecting the AC Input Cord
To connect the AC input cord:
◆ Plug the AC input cord into a properly grounded 120 volts AC, 15 or
20 amp receptacle, connected to an external shore power source such
as a utility grid or a generator.
as a utility grid or a generator.
WARNING: Shock hazard
Connect the AC input cord only to a properly grounded
standard 120 volts AC, 15 or 20 amp receptacle. If the correct
type of receptacle is not available, have an electrician install
one.
standard 120 volts AC, 15 or 20 amp receptacle. If the correct
type of receptacle is not available, have an electrician install
one.
WARNING: Shock hazard
When the On/Standby switch is in the Standby ( ) position and
the XS400 is connected to shore power, AC voltage will be
present at the output of the inverter.
the XS400 is connected to shore power, AC voltage will be
present at the output of the inverter.