Furuno 1834C-BB User Manual

 

After you have installed the equipment, set up the equipment with the installation wizard. 
The wizard allows you to easily set up the NavNet network (choose source of radar, 
sounder and auxiliary), GPS, ports, etc. 
 
1. Press 

the 

POWER/TX key to turn on the power, and the following screen appears. 

EXIT

ENTER

NEXT

LANGUAGE

▲

~

 ENGLISH

{

 FRANCAIS

{

 DEUTSCH

{

 ITALIANO

{

 PORUTGES

{

 ESPANOL

{

 DANSK

{

 SVENSKA

{

 NORSK

  

▼

2. Rotate 

the 

ENTER knob to choose the appropriate language and then push the C: 

ENTER soft key.   

3.  A dialog box asks you if you want to start the simulation mode, which provides 

simulated operation of the equipment. 

4. Press 

the 

CLEAR key to skip the simulation mode. Then, the SELECT MODE window 

appears. When confirming connections only, the simple check mode is useful. 

SELECT MODE

▲

~

 INST. WIZARD

{

 INST. MODE

{

 SIMPLE CHECK MODE

{

 NORMAL MODE

▼

CHANGE OR CONFIRM THE ITEMS SHOWN
ABOVE. THE PUSH [NEXT] WHEN DONE.

5.  Confirm that INST. WIZARD is selected, and then push the A: ENTER soft key. A 

diagnostic test is conducted and then the chart disclaimer message appears. 

6.  You are then asked “LOAD SETTING DATA FROM CARD?”. This allows you to use the 

set up this NavNet unit with the settings of another NavNet unit, thereby shortening the 
time required to set up the equipment. To use the settings of another NavNet unit, insert 
the appropriate SD card in the slot and push the ENTER knob. If not, hit the CLEAR key. 
If you loaded settings, the message “LOADING COMPLETED. REMOVE THE CARD 
AND PRESS ANY KEY TO RESTART” appears if loading was successful. Remove the 
card and press any key to restart the equipment; installation is completed. To set up 
manually, go to step 7.