ALTINEX PNP527 User Manual

400-0464-003

11

Step 1. Refer

to the ALTINEX

website, 

,  to download the latest 

templates and instructions for tabletop
cutting

requirements and installation 

instructions. 

In order to do this, locate the PNP515 on 
the website and go to its detail page. The 
links to the templates, user’s  guide, and 
more are on the left-hand side of the 
screen. 

Step 2. Print all information applicable to the 

installation of the PNP515, including the 
templates and any detailed installation 
instructions.

Step 3. Cut an opening into the table’s surface. 

This operation should be performed by 
experienced professionals in order to 
insure accuracy and to be aesthetically 
pleasing.

NOTE: Always confirm dimensions before 
cutting to insure that specifications have 
not changed. 

Step 4. Install the PNP515 into the table per the 

installation instructions provided on the 
website. 

Step 5. Connect all cables to their appropriate 

sources and/or destinations. The PNP is 
now ready for operation.

The  PNP will open easily when the top is pressed 
down and then released.

When the PNP is not in use, simply press the top 
down until it is level with the surface of the table 
and then release.  The unit will remain hidden until 
needed again. 

Connect external devices to the appropriate 
connector on the PNP.  Remember, the devices 
plugged into the AC power connectors should not 
draw more than 5A AC.

The PNP unit supplied was carefully tested and no 
problems were detected. However, we would like to 
offer the following suggestions:

•

Please make sure that the highest quality 
network cables are used.

•

Make sure that no cable or power cord is 
damaged or pinched. If there has been damage 
to the unit, do not use the PNP. Please contact 
ALTINEX at (714) 990-2300 to have the unit 
repaired. 

Please see the ALTINEX website at 

for details on warranty and 

return policies.

592 Apollo Street

Brea, CA  92821 USA

TEL: 714 990-2300

TOLL FREE: 1-800-ALTINEX