Absocold Corp ARD368A Leaflet
THINGS YOU OUGHT TO KNOW
WHEN YOUR REFRIGERATOR IS INSTALLED
INSPECT
Inspect for shipping damage. If unit is damaged or parts are missing, notify your Absocold dealer at once.
INSTALLATION REQUIREMENTS
Remove all packing material and tape. Install on a level floor or well-supported counter. Avoid any direct sunlight, heat source, or moisture. This
refrigerator is designed to be
refrigerator is designed to be
freestanding
— that is, the appliance is to be installed at least 1½” from the wall and the cabinet bottom is at least ¾” to 1” above
the floor or carpet, in order to let the air circulate freely around the refrigerator. If this appliance is
recessed
,
built-in
or otherwise enclosed to restrict airflow,
then all warranties stated herein are null and void.
ICE STORAGE COMPARTMENT
This compartment is designed for production of ice cubes and short-term storage. The temperature in the ice storage compartment doesn’t get cold
enough to store frozen foods safely.
enough to store frozen foods safely.
ELECTRICAL REQUIREMENTS
120 volts, 60 Hz.
ELECTRICAL GROUNDING
(for 120-volt models only)
Must be grounded. Uses 110-120 volts, 60 Hz.
(60 cycles A.C.) Do not use extension cord. Use three-prong plug, with three-prong grounded wall outlet.
Must be grounded. Uses 110-120 volts, 60 Hz.
(60 cycles A.C.) Do not use extension cord. Use three-prong plug, with three-prong grounded wall outlet.
Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical
component or wiring of refrigerator.
component or wiring of refrigerator.
CAUTION
Should you unplug refrigerator, allow at least three minutes before restarting in order to allow the start relay to function properly.
USE AND CARE INFORMATION
•
TIPS ON EVERYDAY USE AND CARE
TO CONTROL TEMPERATURE
: Start by setting control on No. 3. Wait 24 hours for refrigerator to cool. Higher number is colder. Fresh food section
should be as cold as possible without freezing vegetables or milk. Adjust as necessary.
DEFROST
: This refrigerator is equipped with an automatic defrost timer so that no manual operation is required for defrosting.
The defrost timer is located on the rear wall of this refrigerator. The black segment of the defrost timer dial, from 0 to 3, covers a 3-hour time span and
represents the normal defrosting period--the compressor does not operate during this time.
represents the normal defrosting period--the compressor does not operate during this time.
The defrost timer will continue to operate and will repeat the 3-hour defrost period once every twenty-four (24) hours as long as the refrigerator is
plugged in. The most practical time for automatic defrosting is between midnight and 3 a.m. To accomplish this, set the defrost timer shaft with the arrow
at the number on the timer dial which relates to the time of day/night it is being set.
While defrosting, the defrost water is drained out of the cabinet into an evaporating tray on the rear wall of the refrigerator and is evaporated
automatically. To set the timer shaft, use a screwdriver and turn the shaft CLOCKWISE only.
plugged in. The most practical time for automatic defrosting is between midnight and 3 a.m. To accomplish this, set the defrost timer shaft with the arrow
at the number on the timer dial which relates to the time of day/night it is being set.
While defrosting, the defrost water is drained out of the cabinet into an evaporating tray on the rear wall of the refrigerator and is evaporated
automatically. To set the timer shaft, use a screwdriver and turn the shaft CLOCKWISE only.
FOR ALL CLEANING
: Mix 2 tablespoons baking soda or mild soap with 1 quart warm water. No strong cleaners, scouring powder or pads should be
used. Do not put the defrost tray in the dishwasher. Vacuum the tubing on outside back when dusty.
•
THINGS TO REMEMBER
1.
Allow 24 hours for your refrigerator to reach a new temperature setting.
2.
The motor will start and stop often. It must do so in order to maintain the temperature you select.
3.
Keep your refrigerator reasonably level.
4.
Unplug refrigerator before doing anything with its electrical system (even changing a light bulb).
•
BEFORE CALLING FOR SERVICE
Check plug and outlet. Test outlet with lamp or other device. Be sure control is on. Read all Use & Care Information. Your questions may be answered.
If not, find your model number (on upper back of refrigerator or inside the refrigerator affixed to the inner liner surface on the right-hand side). Refer your
model number and the problem to Absocold Corporation at (800) 843-3714 or (765) 935-7501.
If not, find your model number (on upper back of refrigerator or inside the refrigerator affixed to the inner liner surface on the right-hand side). Refer your
model number and the problem to Absocold Corporation at (800) 843-3714 or (765) 935-7501.
DANGER—ELECTRICAL SHOCK HAZARD. Disconnect power before servicing.
WARNING!
•
Your refrigerator should be connected directly to a grounded electrical wall outlet.
No extension cords, multi-connection bars, etc. should be used.
No extension cords, multi-connection bars, etc. should be used.
•
In case of prolonged power outage or an electrical disconnect of any type, please check your refrigerator for spoiled food.
ENERGY SAVING TIPS -
WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR REFRIGERATOR
•
Reduce door openings.
•
Close the door as soon as you can.
•
Keep coils on back of the refrigerator clean.
•
Adjust temperature control to warmer setting when practical.
•
Don’t put hot foods in refrigerator.
•
Don’t allow more than ¼” of frost to build up in the ice storage compartment.
•
Keep your refrigerator away from stoves and other heat sources.