Polar G600 User Manual

2

UK

To unlock the control panel:

Press and hold the UP 

 and DOWN

 

 buttons simultaneously for 10 

seconds.

Pon flashes on the display and the keyboard is unlocked.

Unlock the control panel, if locked.

Press and hold the SET

 

 button until ‘d1’ flashes on the display.

Press the SET

 

 button repeatedly to scroll to the desired parameter 

(see below).

.

The appliance will automatically run a defrost cycle every six hours. 

To manually defrost the appliance:

Press and hold the DEFROST 

 button for 5 seconds.

The defrost cycle will start immediately and the Defrost LED illuminates. 
The defrost will last a maximum of 30 minutes.

The next automatic defrost will start six hours after the manual defrost 
has finished.

d1

Set the operating temperature of the appliance

-2°C to 10°C

d2

The Temperature Differential is the allowed temperature difference above and below the 

operating temperature before the compressor starts/cuts off

0 to 20°C

d3

Set the minimum (d3) and maximum (d4) temperatures that the appliance can fluctuate 

between

-40°C

d4

95°C

d5

Enter the minimum time interval between the compressor turning off after turning on.

0-999 seconds

d6

Set an alarm to sound if the temperature inside the appliance exceeds the set operating 

temperature by a specified amount

0°C-50°C

d7

Differential Alarm Delay Set a delay before the temperature differential alarm is triggered

0-99 minutes

d8

Set the time between each defrost cycle

1-999 hours

d9

Set the maximum length of the defrost cycle

0-999 minutes

d10

Set the defrost cut-off temperature

-45°C to 50°C

d11

Set an additional amount of defrost time after the defrost cut-off point has been reached (if 

required)

0-99 minutes

d12

Set the length of time the inner temperature of the appliance (before defrost started) is 

displayed for after a defrost cycle has finished

0-99 minutes

d13

Turn the Compressor On or Off during the defrost cycle

On (1) or Off (0)

d14

Set the amount of time the compressor remains turned Off after a defrost cycle, reducing the 

amount of frost build up

0-99 minutes

=19

Should there be any variance between measured and actual temperature, the measured 

temperature can be offset to compensate

-20°C to 20°C

=22

Set whether the temperature is displayed in Centigrade or Fahrenheit

Centigrade (0) or Fahrenheit (1)

=23

Set whether the compressor runs or remains Off during a temperature probe failure

Compressor runs (1)

Remains Off until fault fixed (0) 

Runs intermittently with 

parameters =24 and =25 (2) 

=24

Set the length of time the compressor runs during a temperature probe failure

1-99 minutes

=25

Set the length of time the compressor remains Off during a temperature probe failure

1-99 minutes

=34

Set whether the appliance starts a defrost cycle 10 minutes after startup or after the time 

programmed in parameter d8 (Defrost Cycle Time Intervals)

Begins 10 minutes after startup 

(0) or when programmed (1)

=38

Set the display to flash should the inner temperature of the appliance drop beyond a specified 

point from the programmed operating temperature

1°C to 50°C