Panasonic PT-LB78VE User Manual

Set the selected item with◄►buttons.

 

z

Remote control

Control panel

You can check the using status of the projector.

J

NAME: Name of input signal

 

z

FREQUENCY: Scanning frequency of input 

 

z

signal

J

PROJECTOR: Display current usage time of 

 

z

projector

LAMP: Display current usage time of lamp

 

z

If no image signal is input for the time set with the 

timer, the projector will enter into standby mode 

automatically.

NO SIGNAL SHUT-OFF is disabled

15 - 60 MIN. Timer can be set in intervals of 5 

minutes

You can set the starting method when the mains plug 

is connected to mains socket.

Projector starts from the last image 

before the mains plug was  

disconnected

Projector starts in the standby 

mode

Projector starts immediately

When installing the projector, select the projection 

method according to the projector position.  

Setting on a desk/floor and  

projecting from front

Mounting in the ceiling with a ceiling 

mount bracket (sold separately) and 

projecting from front

Setting on a desk/floor and projecting

from rear (Translucent screen is 

required)

Mounting in the ceiling with a ceiling 

mount bracket (sold separately) and 

projecting from rear (Translucent 

screen is required)

If you use the projector at high elevation, the 

ALTITUDE MODE setting need to be ON to set the 

fan speed high.

For use in normal environment

For use at high altitude

At 1 400 -2 700 m (4 593 - 8 858 ft) sea level, the 

 

z

setting must be 

ON.

The loudness of fan noise depends on the 

 

z

ALTITUDE MODE setting.