Smeg CO100 User Manual

Page of 5
 
INSTRUCTIONS FOR USE
GB 
3. The green LED (if provided) is off and the appliance is 
not working.
Is there a power failure?
Is the plug properly inserted in the socket?
Is the electric cable intact?
4. The green LED (if provided) is off and the appliance is 
working.
The green LED is not working. Contact the After Sales 
Service for a replacement.
5. The compressor runs continuously.
Have hot foods been put in the appliance?
Has the appliance lid been left open for a long time?
Is the appliance placed in a very warm room or near heat 
sources?
Is the thermostat setting correct?
Has the fast freeze function (depending on model) been 
pressed by mistake?
6. Too much ice on the upper edge.
Are the defrost water drainage plugs correctly positioned?
Is the appliance lid properly closed?
Is the appliance lid seal damaged or deformed? (See chapter 
“Installation”)
Have the 4 protection pieces been removed? (See chapter 
“Installation”)
7. Formation of condensate on the external walls of the 
appliance.
It is normal for condensation to form under certain 
atmospheric conditions (humidity above 85%) or if the 
appliance is located in a damp or poorly ventilated room. 
The performance of the appliance is in no way affected.
8. The layer of ice on the internal walls of the appliance 
is not uniform.
This phenomenon is quite normal.
SAFEGUARDING THE ENVIRONMENT
1. Packing 
The packaging material is entirely recyclable, and marked with 
the recycling symbol. Follow local regulations for scrapping. 
Keep the packaging materials (plastic bags, polystyrene parts, 
etc.) out of reach of children, as they are potentially dangerous.
2. Scrapping
The appliance is manufactured using recyclable material
This appliance is marked according to the European directive 
2002/96/EC on Waste Electrical and Electronic Equipment 
(WEEE).
By ensuring this product is disposed of correctly, you will help 
prevent potential negative consequences for the 
environment and human health, which could otherwise be 
caused by inappropriate waste handling of this product. 
The symbol
 on the product, or on the documents 
accompanying the product, indicates that this appliance may 
not be treated as household waste. Instead it shall be handed 
over to the applicable collection point for the recycling of 
electrical and electronic equipment.
Before scrapping, make the appliance unusable by cutting off 
the power cable and removing the doors and shelves so that 
children cannot easily climb inside the appliance.
Disposal must be carried out in accordance with local 
environmental regulations for waste disposal. Deliver the 
appliance immediately to an authorized dump; do not leave it 
unattended even for a few days, since it is potentiallydangerous 
for children. For more detailed information about treatment, 
recovery and recycling of this product, please contact your 
local city office, your household waste disposal service or the 
shop where you purchased the product.
Information:
This appliance does not contain CFCs. The refrigerant circuit 
contains R134a (HFCs) or R600a (HCs), see the rating plate 
inside the appliance.
Appliances with Isobutane (R600a):
Isobutane is a natural gas with low environmental impact. 
Caution is required, however, since isobutane is flammable. 
Therefore, it is essential to ensure that refrigerant pipelines 
are not damaged.
This product contains Fluorinated Greenhouse Gases 
covered by the Kyoto Protocol, the refrigerant gas being in a 
hermetically sealed system. Refrigerant gas: R134a has a 
Global Warming Potential (GWP) 1300.
Declaration of conformity
This appliance is designed to store food and is manufactured in 
conformity with European Directive 90/128/EEC, 02/72/EEC 
and Regulation (EC)  No. 1935/2004 
Thisappliance is designed, manufactured, and retailed in 
compliance with:
- the safety objectives prescribed in the Low Voltage 
Directive 2006/95/CE (which replaced Directive 
73/23/CEE as amended);
- the protection requirements of the "EMC" Directive 
89/336/EEC amended by Directive 93/68/EEC.
The electrical safety of the appliance can only be guaranteed if 
the product is connected to an approved earth connection.
AFTER-SALES SERVICE
Before calling out an After-sales Service technician, 
make sure that:
1.
the plug is properly inserted in the socket;
2.
the mains electrical supply is present;
3.
the meter box safety switch has not tripped;
4.
the power supply voltage corresponds to that indicated 
on the appliance;
5.
if the problem persists, contact the After-sales Service, 
tel. 199.135.135 * (in contact with your local area 
Technician).
Before calling the After-sales Service, be sure to have 
the following information ready:
your full address and telephone number;
the appliance model;
the serial number (“S/N”) of the appliance, indicated on 
the accompanying documentation and on the data plate on 
the rear of the unit;
the nature of the fault.
* Maximum cost 14 cents/min (VAT included) without connection charge 
from landlines. Average cost 39 cents/min (VAT included) and maximum 
connection charge of 15 cents (VAT included) from mobile networks.
For further details on mobile charges, contact your network operator.