Henny Penny CMC/CMR-105 User Manual
Henny Penny
Model CMC/CMR-103,104,105,106,107
3-1. INTRODUCTION
This section provides explanations of all controls, along
with operating procedures and daily maintenance. Read the
Introduction, Installation and Opeation Sections before
operating the unit.
with operating procedures and daily maintenance. Read the
Introduction, Installation and Opeation Sections before
operating the unit.
Wait at least 4 hours before plugging the unit into an
electrical supply. The gases and oils in the refrigeration
system needs to settle before operating the compressor, or
damage to the compressor could result.
electrical supply. The gases and oils in the refrigeration
system needs to settle before operating the compressor, or
damage to the compressor could result.
3-2. OPERATING CONTROLS
Refer to figure 3-1.
Fig.
Item
Description
Function
No.
No.
3-1
1
Power Switch
Turns electrical power off and on to the unit; located on the
bottom of the control panel
3-1
2
Digital Display
Shows the temperatures and the information in the Technical
Mode
Mode
3-1
3
Used to increase setpoint values, as well as programming
values; also, automatic defrost cycles are programmed in
the controls, but to manually start a defrost cycle, press and
hold for 3 seconds to start a manual defrost cycle;
values; also, automatic defrost cycles are programmed in
the controls, but to manually start a defrost cycle, press and
hold for 3 seconds to start a manual defrost cycle;
“DEF/SET’ shows in display
3-1
4
Used to decrease setpoint values, as well as programming
values
values
3-1
5
Press to view the setpoint temperature, or hold it for it for 4
seconds to enter the program mode; once in the Program
Mode, press to view other parameter setpoints;
seconds to enter the program mode; once in the Program
Mode, press to view other parameter setpoints;
Press , along with and to change the
parameters
parameters
SECTION 3. OPERATION
3-1
303