Avanti WID260P User Manual

 

 
Before Using Your Water Dispenser 
•  Check to be sure the following parts are included: 

  Instruction manual 
  Plastic Ice Scoop 

•  Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. 

This will reduce the possibility of a malfunction in the cooling system from handling during 
transportation. 

•  The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed 

with fresh water before use as follows:  

•  Keep the unit unplugged. 
•  Fill water tank with tap water full to capacity. Wait for 5 minutes until water settles. 
•  Turn the child safety button then push the hot water faucet until water comes out, then stop. 
•  Plug the dispenser into the electrical outlet.  We are ready to complete the first cycle. In order to 

do that, wait for the hot water to reach temperature  in approximately 10 minutes, and then wait for 
the cold to reach temperature (another 40 minutes, approximately). 

•  Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at 

a time until no more water remains. 

      (Note: To facilitate this operation, use a large container).   
•  Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains 

completely.  

•  Proceed to close the drain cap.  
•  Remove the cap from the 3 or 5-gallon bottle and use a clean cloth to wipe off the neck of the 

bottle. 

•  Place the 3 or 5-gallon bottle of water on the water intake, allow water to stand for approximately 

one minute.  

•  Push water faucet buttons to insure water flows from each of the faucets. 
•  Plug dispenser back into the electrical outlet.  
•  Now you are ready to use your water dispenser. 

 

 

 

 

NOTE:  Your water dispenser has been cleaned and sanitized before leaving the  

 

  

 factory, but in case a taste problem develops, place two tablespoons of  

          

 baking soda and add tap water. Fill water tank again and repeat basic 

          

 operations previously outlined, except turn hot water function “OFF” to  

 

  

 avoid leaving residues in hot water tank. 

 
ATTENTION: 

 

If you do not plan to use the water heating function for more than three days, we 
recommend that you turn off the hot water function. 

 
 

 
 
 
 
 

 

 



