Insignia NS-LT500P-1 Leaflet

Flat size (W×H): 209.2 × 148 mm.
Final folded size: 104.6 × 148 mm.

INSTALLING THE WATER FILTER

1 YOU MUST SOAK your new filter in water for 15 minutes prior to

installing it in your refrigerator to remove air from the carbon block.

2  Twist the old filter a quarter-turn counter-clockwise.
3  Pull the filter straight down and discard.
4  Push the new filter up into the refrigerator until it stops.
5  Twist the filter a quarter-turn clockwise.
6 Run about two to three gallons of water through your refrigerator’s water

dispenser to remove air and loose carbon pieces. The water may be
cloudy and sputter until the air is removed.

7 Reset your “change filter” indicator (if your refrigerator has one). See

below.

RESETTING YOUR CHANGE FILTER INDICATOR

Note: These are the most common filter reset instructions. If the instructions don’t
work for your refrigerator brand, see the documentation that came with your
refrigerator.

Quick Setup Guide |

NS-LT500P-1

Refrigerator Filter

Before using your new product, please read these instructions to prevent any damage.

Congratulations on your purchase of one of the highest performing
water filters on the market today. Insignia filters use a high-grade
coconut carbon that has 50% more micro-pores than standard carbon.
They also use fewer high-compression binders, giving you the best
water filtration possible.

PACKAGE CONTENTS

• Refrigerator filter(s) (1 pack)
• Quick Setup Guide

GENERAL INSTALLATION GUIDELINES

• It is normal for black carbon fines (particles) to appear on the outside

of your filter. This happens when the filter is jarred in shipping. It is
safe, simply wipe it off.

• Connections on our filters are larger in size to prevent leakage. This

might require more hand leverage to install.

REFRIGERATOR BRAND

INSTRUCTIONS

Press and hold the reset button for three seconds.

NS-LT500P-1_15-0329_QSG_V1_EN.ai 1 4/9/2015 9:06:20 AM

FINAL

FOR PRINT