GE GN1S04C User Manual

6

Be sure there is room underneath the sink to make the needed connections.
Select one of the following places to install the faucet:

—

IN an existing sink spray attachment or soap dispenser hole.

—

IN a hole to be drilled in the sink top.

—

IN a hole to be drilled in the countertop, next to the sink.

NOTE: Looking at second illustration at right, be sure the faucet base will fit 
flat against the surface at the selected location so the gasket will seal. 

If drilling is needed, make a 3⁄ 4

″

dia. hole. Be sure to use the proper

Place small gasket, base and large gasket (in that order) onto the faucet
stem. Next, place lock washer and hex nut onto faucet stud.

Insert washer into tubing adapter. Securely tighten to faucet stud. 

Feed the length of 3 ⁄ 8

″

OD tube from the bottom, up through the

mounting hole. Connect to the tubing adapter as shown in second
illustration, tightening the compression nut securely.

Remove the short shipping tube and insert the spout into the 
faucet body. Rotate spout into place.

Lower the faucet assembly into place on the underside of the mounting
hole. Place the mounting bracket above the lock washer. While holding 
the mounting bracket in place, securely tighten the hex nut.

Sink

Base

Lock washer

Faucet

Lever

Spout

Faucet 
stud

Small gasket

Large gasket

Compression nut

Tubing adapter

Mounting bracket

Hex nut

Plastic washer

3/8

″

tubing, (run 

to 

Filter

outlet)

Compression nut

ASSEMBLED