Faber INCA User Manual

Page of 10
INCA
Power Module Rangehood
• Installation Instructions
• Use and Care Information
READ  AND  SAVE  THESE  INSTRUCTIONS
The Installer must leave these instructions with the homeowner.  
The homeowner must keep these instructions for future reference 
and for local electrical inspectors' use.
READ  THESE  INSTRUCTIONS  BEFORE  YOU  START  INSTALLING  THIS  RANGEHOOD
WARNING: - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:  Keep fan, filters and grease laden surfaces clean.  
Always turn hood ON when cooking at high heat.  Use high range setting on range only when necessary.  Heat oil slowly 
on low to medium setting.  Don’t leave range unattended when cooking.  Always use cookware and utensils appropriate 
for the type and amount of food being prepared.  
WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE 
THE FOLLOWING:  SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner.  BE 
CAREFUL TO PREVENT BURNS.  If the flames do not go out immediately EVACUATE AND CALL THE FIRE DEPARTMENT.  
NEVER PICK UP A FLAMING PAN - You may be burned.  DO NOT USE WATER, including wet dishcloths or towels - a 
violent steam explosion will result.  Use an extinguisher ONLY if: 1. You know you have a Class ABC extinguisher, and 
you already know how to operate it.  2. The fire is small and contained in the area where it started.  3. The fire department 
is being called.  4.  You can fight the fire with your back to an exit.
ALL  WALL  AND  FLOOR  OPENINGS  WHERE  THE  RANGEHOOD  IS  INSTALLED  MUST  BE  SEALED.
This rangehood requires at least 24" of clearance between the bottom of the rangehood and the cooking surface or countertop.  
Overhead cabinets on both sides of this unit must be a minimum of 18" above the cooking surface or countertop.  Consult the 
cooktop or range installation instructions given by the manufacturer before making any cutouts.  MOBILE  HOME  INSTALLATION  
The installation of this rangehood must conform to the Manufactured Home Construction and Safety Standards, Title 24 CFR, Part 
3280 (formerly Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280).  Four wire power supply must 
Version 11/98 - Page 1
LISEZ  BIEN  CETTE  FICHE  AVANT  D'INSTALLER  LA  HOTTE
AVERTISSEMENT: -  POUR RÉDUIRE LE RISQUE DE FEU:  Gardez le ventilateur, les filtres ainsi que toute autre superficie 
propre.  Utilisez la hotte pour cuisson à haute température.  N'utilisez le feu vif que si nécessaire.  Chauffez l'huile 
doucement.  Surveillez toujours la cuisson.  Utilisez toujours des casseroles de taille convenable pour la cuisson.
AVERTISSEMENT: - POUR PRÉVENIR LES BLESSURES EN CAS DE FEU SUIVRE LES RECOMMANDATIONS SUIVANTES:  
ÉTOUFFEZ LE FEU avec un couvercle métallique et fermez le brûleur.  Si le feu ne s'éteint pas tout de suite, QUITTEZ 
LES LIEUX ET APPELEZ LES POMPIERS.  NE TOUCHEZ JAMAIS UNE CASSEROLE EN FLAMMES.  N'UTILISEZ JAMAIS 
DE L'EAU ou un torchon mouillé pour éteindre le feu - ce qui pourrait causer une explosion de vapeur.  N'utilisez un 
extincteur que si: 1.  Vous avez un modèle ABC et vous connaissez bien son mode d'emploi.  2.  Le feu est petit et peu 
répandu.  3.  Les pompiers sont déjà prévenus.  4.  Vous avez une sortie derrière vous.
TOUTE  OUVERTURE  DANS  LE  MUR  OU  LE  PLANCHER  À  PROXIMITÉ  DE  LA  HOTTE  DOIT ÊTRE SCELLÉ
Gardez 24 po. de hauteur entre le bas de la hotte et la surface de cuisson.  Les armoires au-dessus ne dépasseront pas 13 po. 
de profondeur.  Les armoires au-dessus de chaque côté devront être au moins à 18 po. au-dessus de la surface de cuisson.  
Consultez la fiche technique avant de découper les armoires.  L'installation de cette hotte doit être conforme aux Réglements 
de Manufactured Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for 
Mobile Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for Mobile Home 
Construction and Safety, titre 24, HUD, Section 280).  Le branchement électrique se fait avec une raccordement à 4 fils.  Consultez 
la fiche technique électrique.