Gigaset SL370 S30852-H1903-F101 User Manual

Gigaset SL370/SL375 / GBR / A31008-M1903-L101-1-7619 / appendix.fm / 10.10.08

Ve

rs

io

n 4, 16.0

9.20

05

¤

Wipe the base station, charging cradle 

and the handset with a damp cloth (do 

not use solvent) or an antistatic cloth. 

Never use a dry cloth. This can cause a 

build up of static. 

If the handset has come into contact with 

liquid:
1. Switch off the handset and remove 

the battery pack immediately.

2. Allow the liquid to drain from the hand-

set.

3. Pat all parts dry, then place the handset 

with the battery compartment open 

and the keypad facing down in a dry, 

warm place for at least 72 hours 

(not in a microwave, oven etc.).

When it has fully dried out, you will nor-

mally be able to use it again.

If you have any questions about using 

your phone, visit us at 

www.gigaset.com/customercare at any 

time. The table below contains a list of 

common problems and possible solutions.

¥

Reset the Bluetooth headset (see the user 

guide for your headset).

¥

Delete registration data from the handset 

when de-registering the device (see 

¥

Repeat the registration process (see 

The display is blank. 

1. The handset is not switched on.

¥

Press and hold the end call key 

a

.

2. The battery pack is flat.

¥

Charge/replace the battery pack 

pressed. 
The keypad lock is activated.

¥

Press and hold the hash key 

#

 (page 11).

"Base station x" flashes on the display.
1. The handset is outside the range of the base 

station.

¥

Move the handset closer to the base sta-

tion.

2. The base station's range is reduced because 

eco mode is activated.

¥

Deactivate eco mode (page 13) or 

reduce the distance between the hand-

set and the base station.

3. The handset has been de-registered.

¥

Register the handset (page 41).

4. The base station is not switched on.

¥

Check the base station's mains adapter 

Base Search flashes in the display. 
The handset is set to 

 and no base sta-

tion is switched on or within range.

¥

Move the handset closer to the base station.

¥

Check the base station's mains adapter 

Handset does not ring. 
1. The ring tone is switched off.

¥

Activate the ring tone (page 50).

2. Call diversion set to 

¥

Switch off call diversion (page 19).

the fixed network. 
The phone cord supplied has not been used or 

has been replaced by a new cord with the 

wrong jack connections.

¥

Please always use the phone cord supplied 

or ensure that the jack connections are cor-

rect when purchasing from a retailer