Southbend G-72-M User Manual
H
EAVY
D
UTY
C
OUNTERLINE
O
PERATION
O
WNER
’
S
M
ANUAL
1182845
REV
8
P
AGE
21
OPERATION
O
PERATION
!
DANGER
EXPLOSION HAZARD
Purchaser of equipment must post in a prominent location, detailed instructions to be followed in the
event the operator smells gas. Obtain the instructions from the local gas supplier.
event the operator smells gas. Obtain the instructions from the local gas supplier.
!
CAUTION
To eliminate gas build up which could result in an explosion, in the event of main burner ignition
failure a five minute purge period must be observed prior to re-establishing ignition source.
failure a five minute purge period must be observed prior to re-establishing ignition source.
!
CAUTION
Top section pilots, when out, do not interrupt the flow of gas to the burners. Consequently, it is the
responsibility of the operator to check the ignition of the burners, immediately after burner value has
been turned “ON.” Should ignition fail after 10 seconds, turn off burners, wait 5 minutes, and then try
again.
responsibility of the operator to check the ignition of the burners, immediately after burner value has
been turned “ON.” Should ignition fail after 10 seconds, turn off burners, wait 5 minutes, and then try
again.
!
WARNING
UNDER NO CIRCUMSTANCES IS A GRIDDLE TO BE USED FOR HEATING STOCK POTS. SUCH
USE AUTOMATICALLY VOIDS THE WARRANTY.
USE AUTOMATICALLY VOIDS THE WARRANTY.
NEVER COOL A GRIDDLE BY APPLYING ICE OR WATER TO THE GRIDDLE SURFACE.
DAMAGE DUE TO MISUSE IS NOT COVERED BY THE WARRANTY.
DAMAGE DUE TO MISUSE IS NOT COVERED BY THE WARRANTY.
DO NOT STRIKE A GRIDDLE SURFACE WITH THE EDGE OF COOKING IMPLEMENTS TO
CLEAN THE IMPLEMENTS. SUCH ACTION WILL CUT AND PIT THE GRIDDLE PLATE, LEAVING
IT ROUGH AND HARD TO CLEAN.
CLEAN THE IMPLEMENTS. SUCH ACTION WILL CUT AND PIT THE GRIDDLE PLATE, LEAVING
IT ROUGH AND HARD TO CLEAN.
ALWAYS HEAT A GRIDDLE SLOWLY. DO NOT HEAT A GRIDDLE ABOVE 550°F.
LIGHTING AFTER GAS HAS BEEN SHUT OFF
When turning the main gas supply on after the gas supply has been shut off, do the following:
1.
Make sure all of the control valves are in the “OFF” position.
2.
Turn on the gas supply.
3.
Light the pilots as described in each section below.