Alto-Shaam 500-2D User Manual
MN-29742 • Rev. 1 (04/13) • Drawer Warmer Installation/Operation/Service Manual • 6
1.
An identification tag is permanently mounted on
the cabinet.
2.
Plug cabinet into a properly grounded receptacle
ONLY, positioning the unit so the power supply
cord is easily accessible in case of an emergency.
Arcing will occur when connecting or
disconnecting the unit unless all controls are in
the “OFF” position.
3.
If necessary, a proper receptacle or outlet
configuration as required for this unit, must be
installed by a licensed electrician in accordance
with applicable, local electrical codes.
c A u T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.
D A N g E r
DIScONNEcT uNIT frOM
pOwEr SOurcE bEfOrE
cLEANINg Or SErVIcINg.
pOwEr SOurcE bEfOrE
cLEANINg Or SErVIcINg.
D A N g E r
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code ANSI/
NFPA No. 70. In Canada, all electrical
connections are to be made in
accordance with CSA C22.1, Canadian
Electrical Code Part 1 or local codes.
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code ANSI/
NFPA No. 70. In Canada, all electrical
connections are to be made in
accordance with CSA C22.1, Canadian
Electrical Code Part 1 or local codes.
E L E c T r I c A L
I N S T A L L A T I O N
Wire diagrams are located inside the bonnet of the unit.
ELEcTrIcAL
voltage
phase
cycle
/
hz
amps
kW
120
1
60
5.3
0.64
nema
5-15
p
15a, 125V
plug
208-240 1
60
2.7
0.64
nema
6-15
p
15a, 250V
plug
230
1
50/60
2.6
0.59
cee
7/7,
220-230V
plug
For CE approved units: To prevent an electrical
shock hazard between the appliance and other
appliances or metal parts in close vicinity, an
equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances / metal parts
to provide sufficient protection against potential
difference. The terminal is marked
with the following symbol.
NOTE
:
Where local codes and CE regulatory
requirements apply, appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.
hard wired models:
Hard wired models must be equipped with a
Hard wired models must be equipped with a
country certified external allpole disconnection
switch with sufficient contact separation.
If a power cord is used for the connection of the
If a power cord is used for the connection of the
product an oil resistant cord like H05RN or H07RN
or equivalent must be used.