Hoshizaki KMD-901MWH User Manual

0

1. All parts are factory-adjusted. Improper adjustments may result in failure.
. If the icemaker is turned off, wait for at least 3 minutes before restarting the 

icemaker to prevent damage to the compressor.

3. Do not operate the unit in the "WASH" position without water in the water 

tank. This will cause damage to the water pump seal.

1) Open the water supply line shut-off valve.
) Remove the front panel.
3) Move the control switch on the control box to the "ICE" position.
4) Replace the front panel in its correct position.
5) Turn on the power supply and allow the icemaker to operate for 5 minutes to fill up the 

water tank.

6) Remove the front panel and move the control switch to the "WASH" position. Replace 

the front panel in its correct position and allow the icemaker to run for 5 minutes.

7) Turn off the power supply, then remove the front panel.
8) Remove the insulation panel. Remove cube guide B, then remove cube guide A. 

Remove the overflow cap, overflow pipe, and water shield. Remove the drain plug and 
drain the water tank. See Fig. 10.

9) Replace all parts removed in step 8 in their correct positions. Be careful not to cross 

thread the drain plug or overflow pipe.

10) Clean the storage bin/dispenser unit liner using a neutral cleaner. Rinse thoroughly 

after cleaning.

11) Move the control switch to the "ICE" position and replace the front panel in its correct 

position.

1) Turn on the power supply to start the 

automatic icemaking process.

Overflow Pipe

Cube Guide A

Overflow Cap

Water Shield

Drain Plug

Cube Guide B