U-Line SS1095 User Manual

6. Install hinge on opposite side, bottom of cabinet 

(Figure 18). Align hinge outer edge with cabinet 
before tightening screws.

7. Relocate plastic spacer/bushing (Figure 19) on top and 

bottom of door to opposite side. Clean out bushing 
hole in door bottom with a screwdriver if necessary.

8. Using a Phillips screwdriver, remove the two screws 

holding the custom stainless handle from the original 
location, and remove the handle. Remove the two 
screws on the opposite side of the door (Figure 20). Do 
not place handle on door until you have completed 
steps 9 & 10.

9. Remove plastic hole plug (Figure 22) from door handle 

and relocate on opposite side. Lift the handle slightly 
and press on the locking tab, then gently pry the hole 
plug out of the hole being careful not scratch the top 
cap.

10. Relocate plastic spacer/bushing on top of door that was 

underneath the hinge to the opposite hole in top cap

11. Attach handle removed in step 7 to opposite side of 

door frame. Be sure to tighten all four screws removed 
in step 7.

12. Remove pivot screw from top hinge, invert screw and 

reinstall pivot screw in top hinge (Figure 21).

ULIN_0109_A

ULIN_1049_A

Screw

ULIN_0142_A

ULIN_1050_A