Defy Appliances MWA 2434 MM User Manual
24
The +30sec function allows the oven to being cooking immediately on full power.
The +30sec button has been pre-programmed to increase in increments of 30 seconds up to a maximum time of 5 minutes.
The +30sec button has been pre-programmed to increase in increments of 30 seconds up to a maximum time of 5 minutes.
+30sec
1. Press START/+30sec button.
The oven will be “ : 30” is displayed. M/W indicator lights.
And the oven will start immediately. No need to press START/+30sec button.
The oven light comes on and the turn table starts rotaing and the time in the
display will count down in seconds.
And the oven will start immediately. No need to press START/+30sec button.
The oven light comes on and the turn table starts rotaing and the time in the
display will count down in seconds.
1. Open the door.
• Oven stops operating.
• You can restart the oven by closing the door and touching START/+30sec button.
• You can restart the oven by closing the door and touching START/+30sec button.
2. Press the STOP/Clear button.
• Oven stops operating.
• If you wish to cancel the cooking settings, press the STOP/Clear button again.
• If you wish to cancel the cooking settings, press the STOP/Clear button again.
TO STOP THE OVEN WHILE THE OVEN IS OPERATING
If you see arcing, press STOP/Clear button and correct the problem.
Arcing is the microwave term for sparks in the oven. Arcing is caused by:
a) Metal or foil touching the side of the oven.
b) Foil not molded to food (upturned edges act like antennas).
c) Metal, such as twist-ties, poultry pins, or gold rimmed dishes, in the microwave.
d) Recycled paper towels containing small metal pieces being used in the microwave.
a) Metal or foil touching the side of the oven.
b) Foil not molded to food (upturned edges act like antennas).
c) Metal, such as twist-ties, poultry pins, or gold rimmed dishes, in the microwave.
d) Recycled paper towels containing small metal pieces being used in the microwave.
WARNING
ABNORMAL MESSAGE
• If the inside temperature of the oven is higher than expected or the
temperature sensor doesn't work properly, “Err 2” message will be
shown in the display.
shown in the display.
• Unplug the power and call our technical service.
• When the temperature sensor is disconnected, “Err 3” message
will be shown in the display.
• Unplug the power and call our technical service.
This function is used for saving energy.
STAND-BY POWER "0"
To set Stand-by power "0" mode
1. Push the STOP/CLEAR button.
1. Push the STOP/CLEAR button.
“ : 0” appears in the display.
2. Press and hold the STOP/CLEAR button until display is turned off.
3. To cancel the stand-by power "0" mode, press and hold ZERO ON button until
3. To cancel the stand-by power "0" mode, press and hold ZERO ON button until
display is turned on.
The oven is again available for normal use.
The oven is again available for normal use.