Panasonic nn-cd989s User Manual

Page of 30
25
Maintenance
Before Requesting Service
ALL THESE THINGS  ARE  NORMAL:
The oven causes interference 
with my TV.
Some radio and TV interference might occur when you cook with the 
microwave oven. This interference is similar to the interference caused 
by small appliances such as mixers, vacuums, hair dryer, etc. It does not 
indicate a problem with your oven.
The oven lights dim.
When cooking with a power other than P10 – P3, the oven must cycle to 
obtain the lower power levels. The oven light will dim and clicking noises 
can be heard when the oven cycles.
Steam accumulates on the oven 
door and warm air comes from 
the oven vents.
During cooking, steam and warm air are given off from the food. Most of 
the steam and warm air are removed from the oven by the air which 
circulates in the oven cavity. However, some steam will condense on 
cooler surfaces such as the oven door. This is normal.
I accidentally ran my microwave 
oven without any food in it.
Running the oven empty for a short time will not damage the oven. 
However, we do not recommend this to be done.
The oven has an odor and 
generates smoke when using 
the BakeCombination and 
Broil function.
It is essential that your oven is cleaned regularly particularly after 
cooking. Any fat and grease that builds up on the ceiling and walls of the 
oven will begin to smoke if not cleaned.
PROBLEM
The oven is not plugged in 
securely.
Remove plug from outlet, wait 
10 seconds and re-insert.
Circuit breaker or fuse is tripped 
or blown.
Reset circuit breaker or replace 
fuse.
There is a problem with the 
outlet.
Plug another appliance into the 
outlet to check if the outlet is 
working.
The door is not closed 
completely.
Close the oven door securely.
Start Button was not pressed 
after programming.
Press Start Button.
Another program has already 
been entered into the oven.
Press Stop/Reset Button to 
cancel the previous program and 
program again.
The program has not been 
entered correctly.
Program again according to the 
Operating Instructions.
Stop/Reset Button has been 
pressed accidentally.
Program oven again.
Oven is set at Demo Mode.*
Press Micro Power Button once, 
press Start Button 4 times and 
press Stop/Reset Button 4 times 
to turn off Demo Mode.
Roller Ring and oven bottom are 
dirty.
Clean these parts according to 
Care of Your Oven (see next 
page).
POSSIBLE CAUSE
REMEDY
The words “DEMO MODE” 
appear on the screen.
When the oven is turning on, 
there is noise coming from 
Ceramic Tray.
Oven will not start cooking.
Oven will not turn on.
*  DEMO MODE is designed for retail store display. 
Cooking and other functions will not operate during Demo Mode.
If it seems there is a problem with the oven, contact an authorized Service Center.