Multitech MTCBA-Xx-EN2 User Manual
Chapter 3 – Using the Web Management Software
60
MultiModem rCell User Guide
Networks & Services, Network Configuration Parameters
Network Configuration Group
Use this group to add networks or hosts. After you define and add a network, you can delete or edit it by using the
table.
table.
Configuring the Network
Before you configure the network, note the following:
●
You cannot edit a Network/Host Name.
●
You cannot delete a Network/Host another configuration is using it.
●
Network/Host changes are reflected in all the configurations in the Web Management software where they
are used.
are used.
●
Network/Hosts that you add here are displayed in the following sections: Static Routes, DNAT, and Packet
Filters.
Filters.
To configure:
1.
In the Name field, type the name of the Network/Host. Make sure the same address-mask pair does not
already appear in the list. The Name is limited to 15 characters maximum.
already appear in the list. The Name is limited to 15 characters maximum.
2.
In the IP Address field, type the IP Address of the Network/Host. Make sure the same address-mask pair does
not already appear in the list.
not already appear in the list.
3.
In the Subnet Mask field, type the Network Mask of the Network/Host. For Host addresses, the mask is
entered as 32.
entered as 32.
Note:
See Appendix A -- Table of Commonly Supported Subnets.
4.
To add the network, click Add. The defined network appears in the table.