Sharp AR-5516N User Manual

When feeding large 
paper such as B4 and 
A3, pull out the bypass 
tray extension.

To prevent a misfeed, 
verify once more that the 
paper guides are 
adjusted to the width of 
the paper.

• Up to 100 sheets of standard copy paper can be set in the bypass tray.
• Be sure to place A6 or A5 size paper or envelopes horizontally as shown in the following diagram (

).

• When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction flaps 

(not the closure flap).

• Special papers except SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a 

time through the bypass tray.

• When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then 

reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.

• Do not use paper that is smaller than the original. This may cause smudges or unclean images.
• Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause 

smudges or unclean images. 

• If you loaded paper in the bypass tray, 

press the [PAPER SELECT] key (

) to 

select the bypass tray. The bypass tray will 
not be selected automatically.

• If you load thick paper in the bypass tray, 

hold down the [TRAY SETTING] key 
(

) for more than 5 seconds, use the 

[PAPER SELECT] key (

) to select the 

bypass tray, and press the [AUTO IMAGE] 
key (

). When AUTO IMAGE 

indicator (

) lights up, the paper type 

is set to thick paper. The setting is cleared 
when "Auto clear" works or the [CLEAR 
ALL] key (

) is pressed.

AUTO %

AUTO %

Available

Not 

available