Bunn 38200.0016 User Manual

11

Coffee not coming out

Brewed only partial 

decanter

Funnel is overflowing

Coffee is cold

Coffee is not staying hot

Loud rumbling noise

Waterflow begins before lid 

is closed

Deliming tool doesn’t go in 

all the way

Brewer leaks

• Initial set up required - see page 4.

• Make sure lid is closed.

• Evaporation can occur over time - reservoir may need to

  be refilled.  See initial set up on page 4.

•  Requires a minimum of 4 cups (20 oz) to begin brewing.

• Check sprayhead holes, clean if necessary. See deliming

  instructions (step 5) on page 8.
• Evaporation can occur over time - reservoir may need

  refilled.  See initial set up on page 4.

• Some water is always absorbed by the coffee grounds

  and filter. You may need to adjust water input  

 

  accordingly.
•  Use BUNN paper filters.

•  Sprayhead is missing.

•  Decaffeinated, fine grind coffee or softened water is  

  used. See bottom of page 10 to order correct sprayhead 

  or paper filters.
•  Plug in brewer and turn on vacation switch on side    

  of brewer. Allow 15 minutes for water to heat to proper   

  temperature.

•  Warmer switch should be in the “on” position. (BX, GRX,    

 NHBX)

•  If using a BTX with thermal carafe, pre-heating will increase

  the time your coffee will stay warm.
•  Normal while water is heating.

•  May be time to delime. Refer to page 8.

•  Make sure lid is fully open.

•  Brewer is not designed to hold water in upper tray for an

 extended period of time.

•  Remove top lid to ensure rocker arm is snapped in place

  and rubber stopper area is thoroughly cleaned.

•  Refer to deliming instructions (step 3) on page 8.

•  For repair information, go to www.bunn.com, Home Coffee

  Brewers or call 800-352-2866.