Whirlpool ADP8000 User Manual

Page of 22
Compartment
With each wash cycle.
Compartment
With pre-wash only.
(Refer to the
Fill the Detergent and Rinse Aid dispensers
section.)
Check the rinse aid level
Load the baskets
Select a program
Turn on the water tap and press the Start/Pause button. The machine will start working after
about 10 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better. Unload the appliance, starting from the lower basket.
Changing the program
Add forgotten dishes in the
dishwasher
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans, then load the baskets.
It is commended to load the lower basket first, then the upper one. The Max. Capacity is12 settings.
Refer to the dishwasher loading instructions.
Close the door, press the Program button and the selected program light will light up.
( See the section entitled
Operating instruction
.)
When the working cycle has finished, the buzzer of the dishwasher will sound 8 times and then stop, the
program light will stop flashing.
Turn off the appliance using the Power button. Open the door slightly to assist in drying.
If the appliance is switched
off during a wash cycle
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
from the first step.
Switch on the appliance
Press the Power button to switch on the appliance. Open the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button for more than 3 seconds to cancel the running program.
3. Select a new program.
4. Restart the dishwasher.
1.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door,
the dishwasher will
start running again after 10 seconds.
Press the START/PAUSE button to pause the washing;
Press START/PAUSE button,
Press the All-in-1 button to select the function. (Only programs of intensive,
heavy or normal can select the function.)
Press the Half load button to select the function. (Half load function means
that the lower spray arm does not run, so you should load the upper basket only. )
How to use half load function
How to use All-in-1 function
Open the do or car efully.
Hot s team m ay esc ape
when the do or is o pened!
Or via the Mechanical indicator
Electric indicator on control panel.
How to use Delay start function
Press the Delay button to delay the start of washing,
and you can delay the start of washing
for 3, 6 ,9, or 12 hours.