Liebherr EWTN User Manual
A delight in freshness
WFI1051 / EWTN 2956
16
R
EVERSING
D
OOR
H
INGES
18
0°
18
0°
4
25 20
21
25
20
4
21
17
14
16
15
15
12
Figure 13
14. Remove the eccentric (5) with the retaining
screw in the hinge (4).
15. On the upper door: Reinstall the door fittings
(16, 17). Pay special attention to the fitting (17)
with the stop.
with the stop.
16. Place the upper door on the center hinge, fit the
bushing (8), stop (7) and washer on the door,
swivel in the door at the top and insert and
secure the hinge pin (2) from above through the
hinge and stop.
swivel in the door at the top and insert and
secure the hinge pin (2) from above through the
hinge and stop.
17. Re-insert the eccentric (5) with the retaining
screw as shown in the detailed drawing.
Check for proper alignment of all doors. Adjust
them if necessary using the slots on the hinge.
them if necessary using the slots on the hinge.
12. Figure 13: Lift up cover (3) on handle side,
push outward; lift up cover (1) on hinge side
and pull off.
and pull off.
13. Unscrew mounting plate (21): first mounting
screw (20), then inner retaining screw (25).
- Unscrew hinge (4): first remove the mount-
ing screw (20), then retaining screws (25). Fit
hinge (4) to opposite side: for easy assem-
bly, fit hinge from above and first tighten
with the upper retaining screw (25) M5, then
screw (25) and finally mounting screw M4 (20).
hinge (4) to opposite side: for easy assem-
bly, fit hinge from above and first tighten
with the upper retaining screw (25) M5, then
screw (25) and finally mounting screw M4 (20).
- Turn mounting plate (21) 180° and screw tight
again on the new handle side: first retaining
screw (25), then mounting screw (20).
screw (25), then mounting screw (20).