DCS CS-364GL User Manual
UNPACKING AND HANDLING
6
STEP 1:
MOVING AND PLACING THE COOKTOP
MOVING AND PLACING THE COOKTOP
NOTE: If a solid side cabinet wall exists on one or both sides, you will need to notch the
front corner of the cabinet to match the counter top notch and to provide clearance
for the cooktop front (see page 8).
for the cooktop front (see page 8).
CAUTION:
Proper equipment and adequate manpower must be used in moving the
cooktop to avoid personal injury or damage to the unit
cooktop to avoid personal injury or damage to the unit
ANCHORING THE COOKTOP
The cooktops have a shipping weight of approximately 228 pounds (36" models) and 324 pounds (48"
models). After removal of packing materials, it is recommended that the grates and drip pan (below
knobs) be removed to facilitate handling. This will reduce the weight to about 150 pounds.
models). After removal of packing materials, it is recommended that the grates and drip pan (below
knobs) be removed to facilitate handling. This will reduce the weight to about 150 pounds.
DO NOT REMOVE THE GRILL OR GRIDDLE ASSEMBLIES.
It may be necessary to remove the cooktop knobs to pass through some doorways. With the knobs
removed a 29-3/8" wide opening is required. Remove the outer carton and packing material from the
shipping base. The cooktop is held to the skid by four straps. After removing the straps, the cooktop
must be lifted and removed from the skid.
removed a 29-3/8" wide opening is required. Remove the outer carton and packing material from the
shipping base. The cooktop is held to the skid by four straps. After removing the straps, the cooktop
must be lifted and removed from the skid.
The professional cooktop should be moved close to its final location. Electric and gas connections
should be made (steps 5 & 6 pgs. 12 & 13) and the backguard installed (as required, step 4 pg. 11)
before the cooktop is placed in its final position. The grill and griddle sections are fastened in place at
the front with screws. They are designed to be stationary and not meant to be removed for cleaning.
The griddle has two leveling screws beneath the rear flue cover which can be used to adjust the
griddle to the desired slope. The center screw is for shipping and should be removed.
should be made (steps 5 & 6 pgs. 12 & 13) and the backguard installed (as required, step 4 pg. 11)
before the cooktop is placed in its final position. The grill and griddle sections are fastened in place at
the front with screws. They are designed to be stationary and not meant to be removed for cleaning.
The griddle has two leveling screws beneath the rear flue cover which can be used to adjust the
griddle to the desired slope. The center screw is for shipping and should be removed.
Due to the weight of the cooktop, along with a built-in side frame gasket that is meant to rest and
create a seal on the counter top once installed, it is not necessary to anchor the unit to the counter.