Kuppersbusch USA EGS 304.2 User Manual
4
Installation instructions EEB 6800.0 / EEB 6600.0 / EEB 6500.0
Installation under a cooktop
The following KÜPPERSBUSCH built-in cooktops may be installed above the
oven:
oven:
F
* The gap between the countertop and the front panel is not necessary
for the models EGS 304.2 and EKS 304.1.
for the models EGS 304.2 and EKS 304.1.
F
You will find the recess size and installation conditions for the cooktop in
the installation instructions for the cooktop.
the installation instructions for the cooktop.
Electrical supply
=
Only a qualified technian can install a conduit box or replace a connection
cable.
cable.
Conduit box
Don’t install the conduit box in the installation area or above a worktop!
Attach it to the side, underneath the wall, or in a high cabinet under the in-
stallation surface.
stallation surface.
There must be a hole for the conduit cable in either the bottom opening or
the wall.
the wall.
Electrical supply
The power supply should be a 120/240 volts system, 3-wire with ground.
Electrical diagram
for a 120 / 240 volts system,
3-wire with ground:
for a 120 / 240 volts system,
3-wire with ground:
Be sure to install an appropriate conduit box (not furnished) to connect the oven.
Don’t shorten the conduit to facilitate service! The conduit should be routed
to permit the removal of the oven.
to permit the removal of the oven.
Installation, electrical connections and grounding must comply with all appli-
cable local codes.
cable local codes.
■
The conduit-box must be protected by a circuit breaker or fuse, having
amperage as noted in this chapter.
amperage as noted in this chapter.
Connected load
240 V, 60 Hz, 3.6 kW
Fuse current
15 A
– Connect the cable to the conduit box.
F
When the oven is connected, the clock flashes! Set the time as described
in the user’s guide.
in the user’s guide.
Installation
Inserting the appliance
– Push the appliance right into
the cabinet opening. Don’t
pinch the appliance cable!
pinch the appliance cable!
Fastening the appliance
– Open the oven door and attach the
appliance with the enclosed screws -
inserted at an angle - to the cabinet
element from the inside out.
inserted at an angle - to the cabinet
element from the inside out.
Model:
„A“
„B“
„C“
EKE 854.1
EKE 854.2
EKE 804.2
EKE 604.2
EKE 854.2
EKE 804.2
EKE 604.2
30
-5
0
mm
1
-1/
8 t
o 2
“
103 mm
4-1/16"
≥
80 mm
≥
3-1/8"
EGS 304.0*
97 mm
3-13/16"
≥
80 mm
≥
3-1/8"
EKS 304.1*
85 mm
3-3/8"
≥
65 mm
≥
2-9/16"
EKS 604.2
EKS 804.2
EKS 804.2
103 mm
4-1/16"
≥
80 mm
≥
3-1/8"