Sharp Cooktop User Manual

INSTALLATION MANUAL

INSTALLATION

• Review and plan ahead all safety instructions, cabinet

clearances and dimensions, power supply placement and

electrical requirements before installing.

• Proper installation is the responsibility of the installer and

product failure due to improper installation is not covered by

warranty.

Note: This appliance must be properly grounded
Attention Installer: This appliance must be hard wired (direct

wired) into an approved junction box. A plug and receptacle is

NOT permitted on this product.

SELECTING

208 OR 240 VOLT CONNECTION

This appliance can be set for 208V or 240V. The voltage setting for

your appliance is pre-set at 240V from the factory. Follow these

steps to change the voltage setting.

Locate the voltage switch on the left side of the appliance

(facing the front). See Figure 4.

Remove the screw and rotate the switch plate 180˚ as indicated

in the Figure 5.

Reinsert the switch plate and replace screw as indicated

in Figure 6. The voltage setting is indicated by the visible

marking.

180˚

Screw

ADJUSTING ANTI-TIP BRACKET

Measure the thickness of the counter. See Figure 7. Locate the

Anti-Tip Bracket on the backside of the appliance. See Figure 8.

Loosen screws and adjust space between the glass cooktop and

bracket to match the counter thickness plus 1/16”. See Figure 9.

Tighten the screws to secure the bracket at the correct counter height

dimension.

Measure

thickness

Back of unit

Anti-Tip bracket

Loosen screws to adjust

Countertop

thickness +1/16"

from bottom of

cooktop glass bracket

to top of Anti-Tip bracket

Figure 4

Figure 5

Figure 7

Figure 8

Figure 6

Figure 9