Verona VECTEM365 VECTEM304 Use & Care Manual

11

The control uses only the 15% of the available power, 

divided in 0 to 9 steps with a better accuracy. 
Keep in mind that power level 9 in this special mode 

correspond exactly to level 4 in the standard range.
Select the zone and touch the [LOW TEMP] key again 

in order to disable the Low Power Scale and restore the 

standard one, without switching off the zone. 
Pay attention: the level remains the same but the 

power increases.
Switching off a cooking zone as described below 

disables the Low Power mode. When the zone will be 

selected again it will start to work in the standard power 

mode.

Touch the related [OFF] key (ref.1) in order to stop a 

heating element.
You may turn off all active elements at the same time by 

touching the main [ON/OFF] key.

Select a double heating area touching the related [ON] 

key, the HOT SURFACE led (ref.3) begins to flash.
Touch the [DOUBLE] key in order to enable/disable the 

outer ring of a double zone. This operation is possible 

while the HOT SURFACE led (ref.3) is flashing.
The dual element enabling indication (ref.5a) is on 

when the element is enabled, is off when the element 

is disabled.

Select a multiple heating area touching the related [ON] 

key, the HOT SURFACE led (ref.3) begins to flash.
Touch the [TRIPLE] key in order to enable/disable the 

outer rings of a triple zone:
•  If only the inner element is enabled, the intermediate 

ring is enabled too.

• If the inner and the intermediate elements are 

enabled, the outer ring is enabled too.

• If all the elements are enabled, the outer and the 

intermediate rings are disabled.

These operations are possible until the HOT SURFACE 

led (ref.3) is still flashing.
The intermediate element enabling indication (ref.5a) is 

on when the double element is enabled, is off when the 

double element is disabled.
The outer element enabling indication (ref.5b) is on 

when the triple element is enabled, is off when the triple 

element is disabled.

Select one of the two single heating areas belonging 

to the bridge touching the related [ON] key, the HOT 

SURFACE led (ref.3) begins to flash.
Touch the [BRIDGE] key in order to enable the bridge 

element and set the whole cooking area as a single 

unit. 
This operation is possible until the HOT SURFACE led 

(ref.3) is still flashing, before or after setting the power 

level:
•  Set the power level on the selected zone then  touch 

the [BRIDGE] key; both the displays will show the 

same power level and both extension lights (ref.1a, 

1b) turns on.

• Touch the [BRIDGE] key, both HOT SURFACE 

led  (ref.3)  begin  to  flash  and  both  extension  lights 

(ref.6a, 6b) turns on. Set the power level that will be 

immediately and simultaneously displayed on both 

displays.

Once the bridge configuration is active, the [ON] and 

[OFF] keys of the two single zones involved can be 

used indifferently to control the bridge area. All actions 

will have the same effect on the whole cooking area.
The  bridge  configuration  cannot  be  disabled  while  is 

active. It’s always necessary to switch the area off: the 

bridge will be disabled automatically.

Each element has a HOT SURFACE indicator light 

(ref.3) to show when the cooking area is hot. 
This indication turns on when the zone is activated and 

remains ON until the cooking area has cooled down to 

a “safe to touch” temperature (approximately 150°F).