Echo X7672230403 User Manual

2.  Loosely attach bracket (D) to shield (E) and attach shield to bottom 

of gear housing (F) with hardware provided.  

3.  Remove gearcase clamping screws (G) and loosely attach bracket 

(D) to gearcase (F) with 2 - 5x35mm screws, nuts and lockwashers 

provided in kit.

4.  Tighten all hardware.

1.   Check type of gear housing assembly on unit: 

•  Measure PTO shaft.  If shaft is 32 mm,  proceed to step 2.  If 

shaft is 42 mm, proceed to step 3.  If shaft is 45 mm, proceed to 

step 4. 

2.  Install short-necked upper fixing plate (Y) onto PTO shaft. 

3.   Install shaft collar (Z) then short-necked upper fixing plate (Y) 

onto PTO shaft. 

4.   Install long-necked upper fixing plate (X) onto PTO shaft. 

IMPORTANT   

This kit can be mounted on several different style gear housings.  

A long-necked upper fixing plate (X), a short-necked upper fixing 

plate (Y), and a10mm shaft collar (Z) are included in the kit, and 

may be required to properly mount the blade. Failure to install the 

correct upper fixing plate configuration will cause the gearcase to 

bind. Refer to the assembly instructions below to identify upper 

fixing plate assembly.  

                                                                          

Tools Required:  Locking Tool, T-Wrench.
Parts Required:  Upper Fixing Plate w/ 20 mm pilot, Lower Plate, 10 

mm Nut, Split Pin, Blade.