Husqvarna 1153286-26 User Manual
ASSEMBLY
English
–
11
Fitting the loop handle
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
handle must be fitted between the arrows on the shaft.
•
Slide the spacer into the slot in the loop handle.
•
Fit the nut, knob and screw. Do not overtighten.
•
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
position. Tighten the bolt/knob.
Assembling and dismantling the
two-piece shaft
two-piece shaft
Assembly:
•
Loosen the coupling by turning the knob.
•
Align the tab of the attachment (A) with the arrow on
the coupling (B).
the coupling (B).
•
Push the attachment into the coupling until the
attachment snaps into place.
attachment snaps into place.
•
Before using the unit, tighten the knob securely.
Dismantling:
•
Loosen the coupling by turning the knob (at least 3
times).
times).
•
Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
the engine end, pull the attachment straight out of the
coupling.
Assembling the cutting
equipment
equipment
A
B
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
C