Husqvarna 325P5X User Manual
18 –
English
STARTING AND STOPPING
Check before starting
•
Inspect the working area. Remove any objects that could
be thrown out.
be thrown out.
•
Check the cutting attachment. Never use blunt, cracked or
damaged equipment.
damaged equipment.
•
Check that the machine is in perfect working order. Check
that all nuts and screws are tight.
that all nuts and screws are tight.
•
Make sure the chain is adequately lubricated. See
instructions under the heading Lubricating the cutting
attachment.
instructions under the heading Lubricating the cutting
attachment.
•
Check that the cutting attachment always stops when the
engine is idling.
engine is idling.
•
Only use the machine for the purpose it was intended for.
•
Make sure that the handle and safety features are in good
working order. Never use a machine that lacks a part or
has been modified outside its specifications.
working order. Never use a machine that lacks a part or
has been modified outside its specifications.
Starting and stopping
Cold engine
Primer bulb:
Press the primer bulb repeatedly until fuel begins to fill the
bulb. The bulb need not be completely filled.
bulb. The bulb need not be completely filled.
Choke:
Set the choke control in the choke position.
Warm engine
Primer bulb:
Press the primer bulb repeatedly until fuel begins to fill the
bulb. The bulb need not be completely filled.
bulb. The bulb need not be completely filled.
Choke:
Set the throttle to the start position by moving the choke
control to the choke position and then returning it to its original
position.
control to the choke position and then returning it to its original
position.
!
WARNING! The complete clutch cover and
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
Always move the machine away from the
refuelling area before starting. Place the
machine on a flat surface. Ensure the cutting
attachment cannot come into contact with
any object. Make sure no unauthorised
persons are in the working area, otherwise
there is a risk of serious personal injury. The
safety distance is 15 metres.
refuelling area before starting. Place the
machine on a flat surface. Ensure the cutting
attachment cannot come into contact with
any object. Make sure no unauthorised
persons are in the working area, otherwise
there is a risk of serious personal injury. The
safety distance is 15 metres.