SMART Technologies 4000I User Manual

53

In general, you should replace your projector lamp after 7,000 hours of use. At the same time, 
you should replace the air filter with the one that you’ll receive with the replacement lamp. Only 
use the Epson replacement lamp with the SMART part number 01-00159 (Epson part number 
V13H010L26). To obtain this replacement, call your dealer or SMART Technical Support at 
the numbers listed on page 79.

You should also replace the projector lamp if:

•

the image on the screen deteriorates 

•

the image on the screen appears darker than expected

•

you see the Lamp Replace message on the screen

•

you see the lamp warning light on the projector flashing orange

NOTE: If the lamp warning light flashes red, the lamp is burned out and you must replace it.

To replace the lamp and filters, remove the projector from the cabinet by following the 
instructions on page 51. Read the Epson PowerLite 9300i Multimedia Projector User’s Manual 
for instructions and illustrations on replacing these items. When you finish, you should reset 
the lamp timer.

When you receive the 4000i, the laptop umbilical cables are already connected to the 
connection panel. However, should these cables become detached and require reattachment, 
use these instructions and the following two illustrations.