Planar PT1520MU User Manual
10
Start Your Installation
Connecting the Display (Figure 10.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC power cord to the power connector; plug one end
of the AC power cord into the power adapter, and the other end
into an electrical outlet (
into an electrical outlet (
n).
3. Connect the VGA signal cable from display VGA input connector to
the 15-pin connector of your host computer and tighten the screws
(
(
Y).
4. Connect the Audio-In cable from audio input port of your display to
the Audio-out port of your computer (
Z).
5. Connect the USB cable from USB port of your display to the USB
port of your computer (
[).
6. Configure the touch screen. Refer to the “Touch Screen Driver
Installation” section on page 19.
7. Once the touch screen is configured, turn on your computer,
display and video source.
Notice: To ensure the LCD display will work well with your computer, please
configure the display mode of your graphics card to make it less than or
equal to 1024 x 768 resolution and make sure the timing of the display mode
is compatible with the LCD screen. We have listed the “Compatibility Modes”
of this LCD screen in appendices for your reference.
equal to 1024 x 768 resolution and make sure the timing of the display mode
is compatible with the LCD screen. We have listed the “Compatibility Modes”
of this LCD screen in appendices for your reference.