IBM 6C4 User Manual
The Hot-Plug Task has a restriction when running in Standalone or Online Service
mode; new devices cannot be added to the system unless there is already a device
with the same FRU part number installed in the system. This restriction exists because
the device software package for the new device cannot be installed in Standalone or
Online Service mode.
mode; new devices cannot be added to the system unless there is already a device
with the same FRU part number installed in the system. This restriction exists because
the device software package for the new device cannot be installed in Standalone or
Online Service mode.
Depending on the environment and the software packages installed, selecting this task
displays the following three subtasks:
displays the following three subtasks:
v
PCI Hot-Plug Manager
v
SCSI Hot Swap Manager
v
RAID Hot Plug Devices
To run the Hot Plug Task directly from the command line, type the following:
diag
-T"identifyRemove"
If you are running the diagnostics in Online Concurrent mode, run the Missing Options
Resolution Procedure immediately after adding, removing, or replacing any device. Start
the Missing Options Resolution Procedure is by running the diag -a command.
Resolution Procedure immediately after adding, removing, or replacing any device. Start
the Missing Options Resolution Procedure is by running the diag -a command.
If the Missing Options Resolution Procedure runs with no menus or prompts, device
configuration is complete. Otherwise, work through each menu to complete device
configuration.
configuration is complete. Otherwise, work through each menu to complete device
configuration.
PCI Hot Plug Manager
The PCI Hot Plug Manager task is a SMIT menu that allows you to identify, add,
remove, or replace PCI adapters that are hot-pluggable. Refer to the
remove, or replace PCI adapters that are hot-pluggable. Refer to the
PCI Adapter
Placement Reference for information regarding slot restrictions for adapters that can be
used in this system. The following functions are available under this task:
used in this system. The following functions are available under this task:
v
List PCI Hot Plug Slots
v
Add a PCI Hot Plug Adapter
v
Replace/Remove a PCI Hot Plug Adapter
v
Identify a PCI Hot Plug Slot
v
Unconfigure Devices
v
Configure Devices
v
Install/Configure Devices Added After IPL
The List PCI Hot Plug Slots function lists all PCI hot-plug slots. Empty slots and
populated slots are listed. Populated slot information includes the connected logical
device. The slot name consists of the physical location code and the description of the
physical characteristics for the slot.
populated slots are listed. Populated slot information includes the connected logical
device. The slot name consists of the physical location code and the description of the
physical characteristics for the slot.
The Add a PCI Hot Plug Adapter function is used to prepare a slot for the addition of
a new adapter. The function lists all the empty slots that support hot plug. When a slot
is selected, the visual indicator for the slot blinks at the Identify rate. After the slot
location is confirmed, the visual indicator for the specified PCI slot is set to the Action
state. This means the power for the PCI slot is off and the new adapter can be plugged
in.
a new adapter. The function lists all the empty slots that support hot plug. When a slot
is selected, the visual indicator for the slot blinks at the Identify rate. After the slot
location is confirmed, the visual indicator for the specified PCI slot is set to the Action
state. This means the power for the PCI slot is off and the new adapter can be plugged
in.
Chapter 6. Introducing Tasks and Service Aids
133