Allied Telesis XEM-24T User Manual
Installation Guide
21
XEM-2XT Dual 10G BASE-T RJ-45 Ports
The XEM-2 XT Dual 10 GBASE-T RJ-45 expansion module features:
■
two 10GBASE-T RJ-45 ports
■
LEDs showing port status
Front view XEM-2 XT
The following LEDs report operations and faults on the XEM-2XT.
Caution Allied Telesis recommends waiting 30 seconds after hot swapping
any XEM before resuming normal operations. The switch must fully complete
the bootup process before you can hot swap any XEM. Also ensure the XEM
fastening thumbscrews are fully tightened. If you are unsure about correct
procedures, contact your authorised Allied Telesis distributor or reseller.
any XEM before resuming normal operations. The switch must fully complete
the bootup process before you can hot swap any XEM. Also ensure the XEM
fastening thumbscrews are fully tightened. If you are unsure about correct
procedures, contact your authorised Allied Telesis distributor or reseller.
Note You must use Cat 6A cables to enable the XEM-2XT to achieve optimal
performance. In noisy RF environments, we recommend shielded Cat 6A cables.
performance. In noisy RF environments, we recommend shielded Cat 6A cables.
LED
State
Description
L/A
(Link Activity)
Green
A 10 Gbps link has been established.
Green
flashing
flashing
10 Gbps activity is occurring.
Off
A link has not been established.
XEM-2XT
L/A
L/A
10G LINK
ACT
L/A
1
2
XEM_IG.fm Page 21 Wednesday, May 30, 2012 9:24 AM