APC 1400 User Manual
5
English
3.2 Rear Panel
420 and 650 VA
1000 and 1400 VA
The input power connector is a power cord with a NEMA 5-15P connector.
The output power receptacles are NEMA 5-15R type.
The RJ-45/RJ-11 modular combination is used for telephone/network surge protection with
single telephone lines and 10Base-T networks. See section 4.5.
The computer interface port is for UPS monitoring and control. See section 4.4.
The site wiring fault indicator illuminates when the UPS is connected to an improperly wired
AC power outlet. See section 4.9.
The input circuit breaker trips when loads exceed the UPS’s capacity. The resettable center
plungers of the circuit breakers extend when tripped.
The output power receptacles are NEMA 5-15R type.
The RJ-45/RJ-11 modular combination is used for telephone/network surge protection with
single telephone lines and 10Base-T networks. See section 4.5.
The computer interface port is for UPS monitoring and control. See section 4.4.
The site wiring fault indicator illuminates when the UPS is connected to an improperly wired
AC power outlet. See section 4.9.
The input circuit breaker trips when loads exceed the UPS’s capacity. The resettable center
plungers of the circuit breakers extend when tripped.
4. Installation
To obtain warranty coverage fill out and return the warranty registration card now.
4.1 Inspection
Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage. The packaging is re-
cyclable; save it for reuse or dispose of it properly.
cyclable; save it for reuse or dispose of it properly.