Atlona AT-H2H-88M User Manual
13
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
ARC enables a source connected to a display to route audio to an AVR or zone amp.
The S/PDIF port is used for two audio options, ARC or matrix source audio de-embedding. When
using one, the other is disabled. By default the matrix comes with ARC turned off on all ports, this
enables the S/PDIF to de-embed audio from the matrix source. To switch between ARC and matrix
source audio, ARC must be turned on or off. Enable or disable ARC through RS-232 (see page 18)
or front panel (see below).
using one, the other is disabled. By default the matrix comes with ARC turned off on all ports, this
enables the S/PDIF to de-embed audio from the matrix source. To switch between ARC and matrix
source audio, ARC must be turned on or off. Enable or disable ARC through RS-232 (see page 18)
or front panel (see below).
1. Check to be sure the display supports ARC
2. Enable ARC on the HDMI output of the matrix through RS-232 (see page 18) or front panel
(see steps above)
3. Connect the HDMI Matrix output port to the ARC labeled input port on the display
2. Enable ARC on the HDMI output of the matrix through RS-232 (see page 18) or front panel
(see steps above)
3. Connect the HDMI Matrix output port to the ARC labeled input port on the display
NOTE: The Matrix must be connected to the display’s HDMI ARC input
4. Connect the source to a non ARC HDMI input port on the display
5. Connect the S/PDIF port to an AVR or Zone Amp
5. Connect the S/PDIF port to an AVR or Zone Amp
NOTE: The S/PDIF port used must be the same output number as the HDMI port connected
to the display
Audio Return Channel (ARC)
Steps
S/PDIF
HDMI
Bidirectional HDMI w/ARC signal
S/PDIF audio loop-out
Bidirectional HDMI w/ARC signal
S/PDIF audio loop-out
AT-H2H-88M
AT-H2H-88M
DC 24V
ENTER
POWER
EDID
MEMORY
ALL
DEFAULT
CANCEL
FUNCTION
1
2
3
5
6
7
8
4
COAXIAL OUT
HDMI OUT
HDMI IN
RS-232
ETHERNET
IR IN
FIRMWARE
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Select output number
(1-4/8) to set ARC mode
(1-4/8) to set ARC mode
--->
--->
input selection
through
--->
--->
--->
AT-H2H-XXM
Select Input Number
Select Input Number
home screen
Select Function Option
Hold for
5 seconds
5 seconds
--------------------
Output: # Current: On
Select mode 1: On 2: Off
Select mode 1: On 2: Off
Output: # Current: On
Select mode 1: On 2: Off
Select mode 1: On 2: Off
Output: # Current: Off
Select mode 1: On 2: Off
Select mode 1: On 2: Off
--->
--->
--->
--->