Sony 8000SF User Manual
202
Setup
Cha
DME Setup
In DME setup, carry out settings particular to the DME processor.
You can make the following settings.
You can make the following settings.
Input signal settings (Input)
• Initial Crop: Make the initial crop setting.
• Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated
• Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated
by the DME internal matte generator on or off.
• System Phase: Adjust the operation timing of the whole system with respect
to the reference signal.
• TBC Center: Set the TBC window center position.
Output signal settings (Output)
These settings are possible only when the DME is an MVE-9000 or SDI-
interfaced MVE-8000A.
• Monitor Output: Set the signals output from the four monitor output
interfaced MVE-8000A.
• Monitor Output: Set the signals output from the four monitor output
connectors.
• Clip Adjust: Adjust the clip levels of DME1 and DME2 outputs.
Interface with external devices (Device Interface)
• Editor Protocol: Set the protocol to be used on the Editor port.
• Editor Port Setting: Make settings relating to the control of the four editor
• Editor Port Setting: Make settings relating to the control of the four editor
ports installed in the DME.
• GPI Input: Set the GPI input ports and trigger polarities, and make the
action settings.
• GPI Output: Set the GPI output ports and trigger polarities, and make the
action settings.
Setup Relating to DCU Input/Output
In DCU setup, carry out settings particular to the DCU.
You can make the following settings.
• Input Config: Assign GPI inputs to Parallel input ports.
• GPI Input Assign: Make GPI input settings.
• Output Config: Assign GPI outputs to parallel output ports inserted in an
You can make the following settings.
• Input Config: Assign GPI inputs to Parallel input ports.
• GPI Input Assign: Make GPI input settings.
• Output Config: Assign GPI outputs to parallel output ports inserted in an
option slot.
• GPI Output Assign: Make GPI output settings.
• Serial Port Assign: Set the protocol to match the devices connected to a 9-
• Serial Port Assign: Set the protocol to match the devices connected to a 9-
pin serial port. You can also select the control panel used to control each
device.
device.