Sony 8000SF User Manual
363
Transition Preview
Cha
Transition Preview
Carrying out a transition preview
For an overview of the transition preview, see page 46.
1
In the M/E or PGM/PST bank transition control block, press the [TRANS
PVW] button.
PVW] button.
The [TRANS PVW] button lights green, and the switcher is now in the
transition preview mode. At this point, the preview output is the same as
the program output before the [TRANS PVW] button was pressed.
transition preview mode. At this point, the preview output is the same as
the program output before the [TRANS PVW] button was pressed.
2
Operate the fader lever, or press the [AUTO TRANS] button or [CUT]
button.
button.
On the preview monitor, you can check the effect of the transition.
To terminate a transition preview
There are three modes for a transition preview. To terminate a transition
preview, carry out the operation which depends on the mode, and press the
[TRANS PVW] button, turning it off.
Lock: Toggling the [TRANS PVW] button on and off switches between the
There are three modes for a transition preview. To terminate a transition
preview, carry out the operation which depends on the mode, and press the
[TRANS PVW] button, turning it off.
Lock: Toggling the [TRANS PVW] button on and off switches between the
transition preview mode and the normal mode.
Hold: The preview mode obtains only while the [TRANS PVW] button is held
down.
One Time: Each time a transition ends, it reverts to the normal mode.
Set the transition preview mode in the following combinations. For details, see
Chapter 16 “Engineering Setup” (Volume 2).
Set the transition preview mode in the following combinations. For details, see
Chapter 16 “Engineering Setup” (Volume 2).
Notes
• During a transition, whether executed with the [AUTO TRANS] button or
the fader lever, it is not possible to press the [TRANS PVW] button.
• In bus fixed mode (see page 45), transition previews are not available.
• When using the simple-type transition control block (see page 371),
• When using the simple-type transition control block (see page 371),
transition previews are not available.
Transition Preview
mode
mode
Switcher setup
(Transition menu)
<Transition Preview> group
(Transition menu)
<Transition Preview> group
Panel setup
(Operation >Custom Button
menu)
<Trans Pvw> group
(Operation >Custom Button
menu)
<Trans Pvw> group
Lock
Normal
Lock
Hold
Normal
Hold
One Time
One Time
–