Sony 8000SF User Manual
80
DME Wipes
Cha
Note
For the SDI interface on the MVE-8000A or MVE-9000, in some cases the
AUX bus is used in place of the DME external bus.
AUX bus is used in place of the DME external bus.
For details, see “Interfacing With External Devices (Device Interface Menu)”
in “Setup Relating to Switcher Processor” section of Chapter 16 (Volume2).
in “Setup Relating to Switcher Processor” section of Chapter 16 (Volume2).
DME Wipe Pattern Variation and Modifiers
You can modify the selected DME wipe pattern in the same way as an ordinary
wipe pattern, as follows.
wipe pattern, as follows.
For the setting operations, see “Setting DME Wipe Modifiers” (page 469).
Direction: You can set the DME wipe direction to normal, reverse, or
alternating normal/reverse (page 64), except for a key transition, which is
always in normal/reverse mode. However, a key transition can only be
specified when the following patterns are selected, and when other patterns
are selected, this is fixed, as normal/reverse.
Patterns: 1204, 1207, 1221 to 1224
always in normal/reverse mode. However, a key transition can only be
specified when the following patterns are selected, and when other patterns
are selected, this is fixed, as normal/reverse.
Patterns: 1204, 1207, 1221 to 1224
Edge: You can apply a border or soft border (see page 65).
In the case of those user programmable DME patterns for keys in which an
edge has already been applied to the effect, the bahavior is as follows.
• When the DME wipe edge setting is on, only part of the edge applied in
edge has already been applied to the effect, the bahavior is as follows.
• When the DME wipe edge setting is on, only part of the edge applied in
the effect is enabled, and that portion can be adjusted (page 470).
• When the DME wipe edge setting is off, the edge applied in the effect is
enabled as is.
Note
In an MVS-8000 system, edge cannot be used for a key DME wipe.
Positioner: You can move the DME wipe pattern or center of the effect to an
arbitrary position. Using the position select function, you can also
instantaneously move the pattern.
• 1031
instantaneously move the pattern.
• 1031
When this pattern number is selected, with the progress of the transition
the pattern center automatically moves initially from the set position
toward the center of the screen (see page 65). In other words, the effect
obtained is the same as in a normal wipe with the positioner set to
“AUTO CENTER”.
the pattern center automatically moves initially from the set position
toward the center of the screen (see page 65). In other words, the effect
obtained is the same as in a normal wipe with the positioner set to
“AUTO CENTER”.
• 1201 to 1208, 1221 to 1224, 1251
When these pattern numbers are selected, you can set the pattern position
when the first transition completes.
when the first transition completes.